Hayward Booster Pump Model 6060
Hayward Booster Pump Manual
 |
View all Hayward Booster Pump manuals
Add to My Manuals
Save this manual to your list of manuals |
Hayward Booster Pump manual content summary:
- Hayward Booster Pump | Model 6060 - Page 1
IS6060 Rev: B OWNER'S MANUAL INSTALLATION, OPERATION, & PARTS 6060 Booster Pump The Hayward 6060 booster pump is specifically engineered for the demanding requirements of today's in-ground swimming pool cleaning systems. The 6060 booster pump includes an improved seal and impeller design that - Hayward Booster Pump | Model 6060 - Page 2
NEC). Use of non-Hayward replacement parts voids warranty. ATTENTION INSTALLER - THIS MANUAL CONTAINS IMPORTANT INFORMATION ABOUT THE INSTALLATION, OPERATION, AND SAFE USE OF THIS PUMP THAT MUST BE FURNISHED TO THE END USER OF THIS PRODUCT. FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS COULD RESULT IN - Hayward Booster Pump | Model 6060 - Page 3
solid copper conductor, size 8 or larger. Run a continuous wire from external bonding lug to reinforcing rod or mesh. Connect a No. 8 AWG (8.4 mm2) solid copper bonding wire to the pressure wire connector provided on the motor housing and to all metal parts of swimming pool, spa, or hot tub, and to - Hayward Booster Pump | Model 6060 - Page 4
Hayward 6060 booster pump. The instructions in this manual MUST be followed precisely. Failure to install according to defined instructions will void warranty. Product Benefits • 1 1/2" plumbing union fittings improve performance and allow for easy installation and removal. • 3/4" hose barb union - Hayward Booster Pump | Model 6060 - Page 5
6060 Booster Pump Product Specifications Page 5 of 16 Installation Instructions WARNING - This product should be installed and serviced only by a qualified professional. Pump Location Pressure Cleaner Locate booster pump as shown in above diagram and run suction lines as direct as possible to - Hayward Booster Pump | Model 6060 - Page 6
6060 Booster Pump Page 6 of 16 WARNING - Hazardous Pressure. Pumps, filters, and other equipment/ components of a swimming pool filtration system operate under pressure. Incorrectly installed filtration equipment and/or components may fail resulting in severe personal injury or death. - Hayward Booster Pump | Model 6060 - Page 7
Risk of equipment damage. Never run the booster pump without the filtration system operating. Running the booster pump dry will damage the pump and void its warranty. Installation of a separate time clock for the booster pump is recommended. Set timers so that the cleaner turns on at least one half - Hayward Booster Pump | Model 6060 - Page 8
pump. NOTE - If the 6060 booster pump is used to replace the booster pump in an existing pressure cleaner installation, then the cleaner operating pressure should be reset according to the cleaner manufacturer's recommended procedure. WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward Booster Pump | Model 6060 - Page 9
from seal plate (see Parts Diagram on page 11 of this manual for pump component locations), and completely drain water from booster pump. 4. Winterize above and below ground piping in accordance with winterizing practices. 5. Refer to pressure cleaner owner's guide for cleaner system winterizing - Hayward Booster Pump | Model 6060 - Page 10
6060 Booster Pump Page 10 of 16 Shaft Seal Change Instructions (cont'd.) Removing the Motor Assembly (See Parts Diagram on page 11 of this manual for pump component locations.) 1. Remove the eight (8) 1/4" x 1-1/4" self-tapping screws (item #1), which hold the volute (item #2) to the seal - Hayward Booster Pump | Model 6060 - Page 11
of 10) Pump Volute Union Connector Kit (incl. 2 ea. Union Hose Connector, Union Pipe Connector, Union Nut, and Union O-Ring) Impeller Assembly Seal Plate O-Ring Shaft Seal Assembly Seal Plate Assembly (incl. Drain Plug w/O-Ring) Drain Plug w/O-Ring Motor Support Motor Bolt Motor, ¾ HP, Square Flange - Hayward Booster Pump | Model 6060 - Page 12
the pump housing. 4. Motor bearings noisy from normal wear, rust, overheating, or concentration of chemicals causing seal damage which will allow chlorinated water to seep into bearings wiping out the grease causing bearing to whine. Solution: All leaking seals should be replaced at once. © Hayward - Hayward Booster Pump | Model 6060 - Page 13
Page 13 of 16 PRODUCT REGISTRATION (Retain For Your Records) DATE OF INSTALLATION INITIAL PRESSURE GAUGE READING (CLEAN FILTER BOOSTER PUMP MODEL: 6060 HORSEPOWER: 0.75 FRHP (1.25 THP) FILTER MODEL BOOSTER PUMP SERIAL NO WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward Booster Pump | Model 6060 - Page 14
6060 Booster Pump Page 14 of 16 THIS PAGE IS BLANK WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward Booster Pump | Model 6060 - Page 15
6060 Booster Pump Page 15 of 16 HAYWARD® LIMITED WARRANTY This pump was inspected before shipment from our plant. To original purchasers of this pump, Hayward Pool Products, 620 Division Street, Elizabeth, New Jersey, warrants its products free from defects in materials and workmanship for a - Hayward Booster Pump | Model 6060 - Page 16
6060 Booster Pump Page 16 of 16 THIS PAGE IS BLANK WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
 |
 |
P/N:
IS6060
Rev:
B
__________________________________________________________________________________________
OWNER’S MANUAL
INSTALLATION, OPERATION, & PARTS
6060 Booster
Pump
The Hayward 6060 booster pump is specifically engineered for the demanding requirements of today’s in-ground swimming pool
cleaning systems.
The 6060 booster pump includes an improved seal and impeller design that will provide many years of efficient,
dependable, corrosion-free service.
The advanced design provides superior performance while reducing maintenance requirements.
NOTE -
To prevent potential injury and to avoid unnecessary service calls, read this manual carefully and completely.
SAVE THIS INSTRUCTION MANUAL
HAYWARD POOL PRODUCTS
620 DIVISION STREET
ELIZABETH, NJ
07207
(908) 351-5400
WWW.HAYWARDPOOL.COM