Hayward E-Command 4 Model: ALL MODELS Installation - Page 14
Raypak RP2100 Pool/Spa Heater - 6 button remote
View all Hayward E-Command 4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Raypak RP2100 Pool/Spa Heater 1. Turn power off to heater. 2. Push the mode button to "spa" mode. 3. Set the temperature to the maximum. 4. Push the mode button to "OFF". 5. Lastly, plug the prewired connector in the P7 position on the board. ! IMPORTANT: The heater will display "OFF" when it is being remotely controlled by the ECOMMAND 4. Some homeowners see the "OFF" display and, thinking this is a mistake, change the mode to "POOL" or "SPA" which then disables the remote control by the ECOMMAND 4. To prevent this: Remove the heater touch pad connector (P5) which will disable the touchpad. Black Orange Stripe Orange Black Stripe Light Blue P7 Pool/Spa Air Solar Heater Drawing is for digital heater. If heater is a millivolt (analog), run red wires from Fireman's Switch to heater relay. RAYPAK RP2100 STA-RITE Heater 1. Turn power off to heater. 2. Remove upper jacket and open the control box. 3. Remove the jumper for the "fireman's switch. 4. Wire to the ECOMMAND 4 using wire rated for 105°C minimum. Fireman's Switch Operating 'Control Terminal Board STA-RITE Pool/Spa Air Solar Heater 11