Hayward E-Command 4 Model: ALL MODELS Installation - Page 22
Allow Low Speed, Lights Function
View all Hayward E-Command 4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Allow Low Speed This menu only appears if the pool filter is configured for 2-speed or variable speed operation. During default operation, high speed mode is used whenever the solar heater is on. If Allow Low Speed is enabled, low speed pump operation will be allowed during solar heating except for the first 3 minutes after solar heat turns on. Lights Config. + to view/change Push to access Lights options Move to previous/next configuration menu Lights Function Manual On/Off for manual on/off, countdown timer and timeclock functions Lights Relay Standard Rotates between Manual On/Off (default), Countdown Timer, Low Speed- Filter, Timeclock, Solar, and Super Chlorinate Move to next menu item Toggle between Standard (default) and Dimmer Move to next menu item or previous/next configuration menu for all functions except dimmer relay, solar super chlorinate, and low speed Lights Interlock Toggle between Enabled and Disabled (default) Lights Interlock Disable Move to next menu item for all functions except dimmer relay, super chlorinate, and low speed Lights Freeze Toggle between Enabled and Disabled (default) Lights Freeze Disable Move to next menu item or previous/next configuration menu only if filter pump is set to variable and relay type is set to standard Lights Pump Spd Settings Menu Select between Settings Menu (default) and the desired pump speed Move to previous/next configuration menu Lights Function Although designated as the "Lights" output, the function of the lights relay is similar to the aux1 and aux2 relays. If pool lights are wired to the lights relay, some options including Solar function, Low Speed of a 2-Speed Filter Pump, Lights Interlock and Lights Freeze Protection will not be necessary and should be disabled. If no pool lights are used, the lights relay can be used to control other pool devices that may require these options. The function of each option is shown below. Manual On/Off (default)-the lights relay will alternate between turning on and off when the LIGHTS button is pressed. There is no automatic control logic. Countdown Timer-the lights relay will turn on when the LIGHTS button is pressed. The lights relay will turn off automatically after a programmed time (see Timers Menu in Operation Manual). The LIGHTS button can also be used to turn the output off. Low Speed of a 2-speed Filter Pump - the ECOMMAND 4 will turn on the lights relay whenever the low speed operation of the filter pump is required. It is very important that the "2-speed" filter pump option be selected under the "Filter Config." Menu for proper operation. Timeclock - the lights relay will turn-on and turn-off at the times set for the lights timeclock in the Timers Menu (see Timers Menu in Operation Manual). The LIGHTS button can also be used to turn the output on and off. Solar - the lights relay can operate a solar booster pump which will turn on when the filter pump is running and solar heat is available and the water is less than the desired temperature setting. It is important to note that "Solar Control" must be enabled in the "Solar Config." menu for proper operation to occur. 19