Hayward E-Command 4 Model: ALL MODELS Installation - Page 4
Introduction - act rf
View all Hayward E-Command 4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Introduction Before You Begin What's Included Before attempting to install the ECOMMAND 4 system, check that the following components have been included in the package: ECOMMAND 4 Electronics Unit (3) Temperature sensors with 15 ft. (5m) cable, hose clamp (2) Goldline GVA-24 actuators (HPC-4-ACT, HPC-4-ACT-RC only) (1) Goldline AQL2-BASE-RF/AQL2-SS-RF remote control (HPC-4-RC, HPC-4-ACT-RC only) What's NOT Included Some of the additional items that you may need to complete an installation include: Circuit breakers None are included with control-see page 6 and inside of door for suitable breakers Wire 4-conductor cable (electronics unit to external chlorination) Wire/conduit for 100A service from main panel to ECOMMAND 4 Wire/conduit for filter pump and other high voltage loads Wire for bonding Miscellaneous Mounting hardware (screws, etc.) for mounting ECOMMAND 4 Valves (use standard Hayward, Pentair/Compool, or Jandy valves) Additional valve actuators Accessory Products - Order Separately AQL2-SS-RF Wireless Spa Side Remote Control (Included with HPC-4-RC, HPC-4-ACT-RC) AQL2-BASE-RF Base Station required if using AQL2-SS-RF (Included with HPC-4-RC, HPC-4-ACT-RC) AQL-DIM Light Dimmer Relay GVA-24 Valve Actuator V&A-xx Valve & Actuator (xx=1P (1.5" pos. seal), -2P (2" pos. seal), (Included with HPC-4-ACT, HPC-4-ACT-RC) Installation Steps Details on each installation step are presented on the following pages: 1. Mounting the equipment (page 2) ECOMMAND 4 main unit Temperature sensors Optional Remote Control Optional Base Station Valve actuators (if applicable) High Voltage pool equipment Low voltage wiring (temperature sensors, heater, etc.) 4. ECOMMAND 4 configuration (page 14) 2. Plumbing (page 4) General Pool Equipment 5. System Startup and checkout (page 24) 3. Electrical Wiring (page 6) Main service Grounding and bonding Circuit breakers ECOMMAND 4 control power 1