Hayward Perflex® Extended-Cycle Owners Manual
Hayward Perflex® Extended-Cycle Manual
 |
View all Hayward Perflex® Extended-Cycle manuals
Add to My Manuals
Save this manual to your list of manuals |
Hayward Perflex® Extended-Cycle manual content summary:
- Hayward Perflex® Extended-Cycle | Owners Manual - Page 1
Manual IS50C Rev C MODEL: EC50AC PERFLEX® Extended Cycle Filter This is the safety-alert symbol. When you see this symbol on your equipment or in this manual special instructions that are important but not related to hazards. SAVE THIS INSTRUCTION MANUAL Hayward Pool Products One Hayward Industrial - Hayward Perflex® Extended-Cycle | Owners Manual - Page 2
instructions. • Do not operate water circulation system if a system component is assembled improperly, damaged, missing, or not a genuine Hayward component. • Before performing maintenance on the water circulation system, verify all system and pump controls are in OFF position and filter manual - Hayward Perflex® Extended-Cycle | Owners Manual - Page 3
installation of a safety vacuum release system conforming to ASME A112.19.17, or an approved gravity drain system. • Failure to remove pressure test plugs and/or plugs used in winterization of the pool USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 3 of 12 PERFLEX™ Filtration Series IS50C REV C - Hayward Perflex® Extended-Cycle | Owners Manual - Page 4
The Hayward-Perflex is a high performance swimming pool filter with a filtration rating of 3,000 gallons (11 KL) per hour. Manufactured from durable, corrosion-proof materials, it is designed for continuous operation, for installation above or below, the pool water line. It may be used on fresh or - Hayward Perflex® Extended-Cycle | Owners Manual - Page 5
system will automatically vent to the pool. When there is a steady flow of water returning to the pool, the filter is ready for precoating. DO NOT operate the filter for more than one minute without the precoat charge. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 5 of 12 PERFLEX™ Filtration - Hayward Perflex® Extended-Cycle | Owners Manual - Page 6
7-10 psi (.49-.70 Bar) above the precoat pressure, regenerate the filter. REGENERATION (Extending the Cycle) Stop the pump. Move the bump handle down slowly, then up briskly. Repeat 3 times. Restart the pump and filtration will resume at near the original flow and pressure. After each regeneration - Hayward Perflex® Extended-Cycle | Owners Manual - Page 7
Filter Head with Vent Valve 1 4 ECX5000C Clamp Assembly with Spring 1 5 ECX100Z9 Pivot Pin (long) 1 6 ECX4236 Shoulder Screw 1 7 ECX1040 Bump Handle 1 8 ECX1037B Bump Handle Nipple 1 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 7 of 12 PERFLEX™ Filtration Series IS50C REV C - Hayward Perflex® Extended-Cycle | Owners Manual - Page 8
drained and removed from its operating location and stored indoors. Prior to removal, cycle the filter as described under CLEANING. SERVICE & REPAIRS Consult your local authorized Hayward-Perflex dealer or service center. No returns may be made directly to the factory without the expressed written - Hayward Perflex® Extended-Cycle | Owners Manual - Page 9
motor trouble shooting speed) guide. NOTE: Most motor problems are due to: 1.Undersized or improper wiring. 2. Power cut-backs or a combination of both. 1. D.E. loaded to capacity with pool dirt, algae, etc. 1. Bump-Drain-Recharge. Short cycles. 2. Bumping incorrectly. 3. Bump handle bent - Hayward Perflex® Extended-Cycle | Owners Manual - Page 10
agents, which will clog filter. 1. Bump-Drain-Recharge more often. 2. Add enough chlorine to control this growth - then vacuum. 3. Vacuum so as to by-pass filter. Avoid using floccing agents. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 10 of 12 PERFLEX™ Filtration Series IS50C REV C - Hayward Perflex® Extended-Cycle | Owners Manual - Page 11
specific legal rights, and you may also have other rights, which vary from state to state. Hayward Pool Products, Inc. 620 Division Street Elizabeth, NJ 07207 *Supersedes all previous publications. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 11 of 12 PERFLEX™ Filtration Series IS50C REV C - Hayward Perflex® Extended-Cycle | Owners Manual - Page 12
New Installation Replacement Installation for: In ground Above Ground Spa USE ONLY HAYWARD GENUINE REPLACEMENT PARTS PERFLEX Hayward is a registered trademark and PERFLEX is a trademark of Hayward Industries, Inc. © Hayward Pool ProducPtsa. 2g0e101A2llorigfh1ts2reserved ™ Filtration Series
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
 |
 |
PERFLEX
™
Owner’s Manual
MODEL: EC50AC
PERFLEX
®
Extended Cycle Filter
SAVE THIS INSTRUCTION MANUAL
This is the safety-alert symbol. When you see this symbol on your equipment or in this manual, look for one of the
following signal words and be alert to the potential for personal injury or death.
WARNING
Warns about hazards that
could
cause serious personal injury or, death, and or major property damage
and if ignored presents a potential hazard.
CAUTION
Warns about hazards that
will
or
can
cause minor or moderate personal injury and/or property damage
and if ignored presents a potential hazard.
It can also make consumers aware of actions that are unpredictable and
unsafe.
The
NOTICE
label indicates special instructions that are important but not related to hazards.
IS50C
Rev C
by
Hayward Pool Products
One Hayward Industrial Drive, Clemmons, NC 27012
Phone: 336-712-9900
www.haywardnet.com