Hayward Pro-Grid Model C9002SEP

ISC9002SEP-00

HAYWARD PRO GRID

D.E. SEPARATION TANK

MODEL C9002SEP

OPERA

TION

NOTE:

BE

SURE

THE

LOCKING

KNOB

AND

DRAIN

PLUG

ARE

SECURELY TIGHTENED.

Stop the pump and set the filter control valve to the backwash position.

Open the by-pass valve (if equipped) and manual air relief valve and start the pump.

Close the air relief valve after

all the air is evacuated.

Backwash the filter for approximately 2 minutes (or until water in optional

sight glass is clear).

Stop the pump, set the filter control valve to the filter position and close the by-pass valve (if equipped).

CLEANING

Clean separation tank bag after each filter backwash.

WARNING:

THIS SYSTEM OPERATES UNDER PRESSURE. BEFORE REMOVING TOP COVER, BE SURE PUMP IS

OFF AND AIR RELIEF VALVE IS OPEN TO RELEASE ALL INTERNAL PRESSURE. ALWAYS MAKE SURE

TOP

COVER LOCKING KNOB IS SECURELY

TIGHTENED BEFORE TURNING ON PUMP. PERSONAL

INJURY OR

PROPERTY DAMAGE

COULD

OCCUR.

Remove the drain plug, open the air relief valve and allow the water to drain from the separation tank.

Unscrew locking knob (counter clockwise direction).

Carefully lift off top cover to gain access to bag.

Lift out bag and properly dispose of accumulated dirty D.E. into a waste container. Rinse bag.

Carefully re-install bag in separation tank assuring that the bag assembly sits securely on the

collector hub in the bottom of the separation tank body.

Rinse off cover and O-ring to insure a reliable sealing surface.

Place cover on separation tank body.

Tighten locking knob in clockwise direction (hand tight only).

Install and tighten drain plug and close air relief valve.

1.

2.

3.

4.

1.

2.

3.

4.

5.

6.

7.

8.

TYPICAL INSTALLATION

OWNER’S GUIDE

RETURN TO

POOL OR

WASTE LINE

To Pool