Hayward Pro Logic® Model: Pro Logic Installation Addendum Oct 08 or later

Installation Manual Addendum

The following information is intended to replace the instructions found in the “

High Voltage (120/

240V) Pool Equipment” section on page 12 or 14 of your

Installation Manual.

If using a Hayward

Variable Speed Pump, disregard the installation instructions found in the manual and refer to the

information below.

Hayward Variable Speed Pump:

Proper installation of a Hayward Variable Speed Pump (VSP) includes high voltage

input wiring, low voltage communication wiring, and menu configuration/settings.

This Pool Control can operate up to 2

Hayward TriStar VSPs and 4 EcoStar VSPs.

Refer to the diagram below for proper input wiring to the VSP. Wiring from

the 220V breaker must NOT connect through the Filter/Lights/Aux relay.

The following instructions are intended to replace the information found in the “

Low Voltage Wiring

”

section on page 16 or 18 of your Installation Manual.

Disregard the installation instructions found

in the manual and refer to the information below.

Hayward Variable Speed Pump (VSP) Wiring and Address Setting

Refer to your TriStar or EcoStar manual(s) for proper low voltage communication wiring between the Pool Control and the

Hayward Variable Speed Pump.

A pump address must be configured for each VSP used in the system.

This address is unique to the output used on the

control, and is entered in the VSP’s configuration menu.

Refer to the table below to determine which address to use. Select

the proper address based on which output will be used and the model VSP you are configuring.

Once configured, the

output will control the VSP.

092465 RevA

FILTER - all models

AUX1 - all models

Dual Equipment Spa Filter - all models

A

2 - all models

A

3-A

6 - PS8 & PS16 models

A

7-A

14 - PS16 models

UX

UX

UX

UX

UX

LIGHTS - all models

Pool Control Output

VSP Address

This is the name that should be selected

under “Set COMM bus address” (EcoStar)

or “*H.Comm ADDR.” (TriStar) within the

VSP’s Configuration Menu.

“001” - Tristar

“Pool Filter” - EcoStar

“002” - Tristar

“

” - EcoStar

Aux1 / Spa Filter

“Lights Button” - EcoStar only

Aux2-Aux14 - EcoStar only

(use same as Pool Control Output)

This is the output that will be used

to control the VSP.