Hayward Salt & Swim 3C Salt & Swim 3C Owner's Manual
Hayward Salt & Swim 3C Manual
 |
View all Hayward Salt & Swim 3C manuals
Add to My Manuals
Save this manual to your list of manuals |
Hayward Salt & Swim 3C manual content summary:
- Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 1
092511 RevA Salt & SwimTM 3C Chlorine Generator for Inground Swimming Pools up to 30,000 gallons Owner's Manual Contents Introduction 1 Installation 2 Operation 12 Troubleshooting........... 15 Warranty 21 Model: SAS Hayward Pool Products 620 Division Street, Elizabeth NJ 07207 www.hayward.com - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 2
safety precautions should always be followed, including the following: • READ AND FOLLOW ALL INSTRUCTIONS • TO REDUCE THE RISK OF DROWNING FROM HAIR AND BODY ENTRAPMENT, INSTALL A conductor not smaller than No. 6 AWG. • SAVE THESE INSTRUCTIONS USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 3
eliminating the need to add sanitizing chemicals to your pool. Salt & Swim 3C can handle the purification needs of most residential swimming pools up to 30,000 gallons (114,000 liters). This a buildup of by-products that can damage your chlorinator Cell. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 4
you intend to operate the Salt and Swim. To prepare your pool water, follow the instructions on the included Pool Chemistry Quick Start Guide and refer to page 8 of this manual. Adding Salt: Add salt several hours or, if possible, 1 day prior to operating the Salt & Swim 3C . Take care not to exceed - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 5
not to block the four sides of the Control Box. Do not mount Salt & Swim 3C inside a panel or tightly enclosed area. Before securing the Control Box to or 2" PVC pool plumbing. For pools using 1½" polypipe, you must use a Hayward DIY-POLYPIPE adapter kit. The Cell Vessel must be installed on a 10" - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 6
marker to mark the pipe. When finished, there should be 12 marks on the pipe. Follow procedures on the Installation Quick Start Guide to complete Vessel installation. 1 Mark Pipe 2 Cut Pipe and Clean Shavings 3 Slide Nuts on Pipe 4 Slide Compression Rings on pipe 5 Slide Collars - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 7
pins with supplied grease. Verify that the O-ring is attached to the Cell before inserting the Cell into the Cell Vessel as shown. 5 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 8
is required at your location (see Local and NEC codes), a bonding lug is provided at the bottom of the Salt & Swim 3C enclosure. Run an eight gauge (8 AWG) solid copper wire from the bonding lug to your pool's existing bonding loop. to Pool Bonding loop 6 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 9
Guide as well as the "Water Chemistry" section of this manual for information on how to prepare your pool water for Salt & Swim 3C operation. At start-up, or when a new Cell is installed, Salt & Swim 3C refer to the Troubleshooting section of this manual. 7 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 10
strips and refer to the Chemistry Quick Start Guide information on testing and adjusting your pool's water chemistry. Your Authorized Salt & Swim 3C Dealer or most pool stores can provide you or irritation may occur. -.2 0 .2 CORROSIVE SCALING 8 OK USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 11
salt according to the chart on page 10. A low salt level will reduce the efficiency of the Salt & Swim 3C and result in low chlorine production. A high salt level can cause the Salt & Swim 3C to allow the salt to evenly disperse throughout the pool. The only way to lower the salt concentration is to - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 12
POUNDS and (Kg) of SALT NEEDED FOR 3200PPM Current salt Gallons and (Liters) of Pool Water level 8,000 10,000 12,000 14,000 16,000 18,000 20,000 22,000 OK OK OK OK OK OK OK 3600+ Dilute Dilute Dilute Dilute Dilute Dilute Dilute Dilute Dilute Dilute 10 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 13
11 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 14
its expected life. When this LED indicator is illuminated, there is a problem with the unit. Refer to the Troubleshooting section of this manual. Illuminates when unit is waiting for the filter pump to turn on , press the SUPER CHLORINATING button again. 12 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 15
from the Salt & Swim 3C unless pool components are being serviced or the pool will be closed. When power is first applied to the Salt & Swim 3C, an over-chlorination. Salt & Swim 3C stops generating when the pool water temperature drops below 50ºF. This is usually not a problem because bacteria and - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 16
the Salt & Swim 3C System The replaceable Cell uses the same electronic self cleaning technology as the popular Hayward Turbo Cell balance," the Cell may require periodic cleaning. Servicing and Cleaning the Salt & Swim 3C Cell Unplug Salt & Swim 3C from the GFCI outlet and remove power from - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 17
www.hayward.com or call 855-429-9274 for helpful information on operation, maintenance and troubleshooting your Salt & Swim 3C Electronic Chlorine Generator. Common Problems and Solutions The Salt & Swim 3C's various LEDs show the operation status as well as alert the user to any problems that - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 18
the Cell is scaled, follow the directions on page 14 for Cell cleaning. 8. PROBLEM DETECTED LED illuminated AND a DAILY CHLORINE OUTPUT LED is blinking Salt & Swim 3C may display an error by illuminating the PROBLEM DETECTED LED and blinking one of the DAILY CHLORINE OUTPUT LEDs. There are ten - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 19
. 2. Inspect the cable that connects the cell to the system. Make sure the cable is secure and undamaged. 3. Contact Hayward Technical Service. 1. Recycle power to the Salt & Swim by unplugging the linecord for two minutes Inadequate and then plugging it back in. Water Flow 2. Perform "Flow Switch - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 20
18 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 21
19 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 22
20 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 23
(effective 12/01/12) Hayward warrants its Salt & Swim 3C chlorination products to be free of defects in materials and workmanship, under normal use and service as follows: Control Box - 2 year limited warranty, parts only SAS-CELL - 1 year limited warranty Hayward warrants all accessories and other - Hayward Salt & Swim 3C | Salt & Swim 3C Owner's Manual - Page 24
FOR FURTHER INFORMATION OR CONSUMER TECHNICAL SUPPORT, VISIT OUR WEBSITE AT www.hayward.com Hayward is a registered trademark and Salt & Swim is a trademark of Hayward Industries, Inc. © 2012 Hayward Industries, Inc. All other trademarks not owned by Hayward are the property of their respective
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
 |
 |
Salt & Swim
3C
TM
Owner’s Manual
Model: SAS
Contents
Introduction
....................
1
Installation
.....................
2
Operation
......................
12
Troubleshooting
...........
15
Warranty
........................
21
Hayward Pool Products
620 Division Street, Elizabeth NJ 07207
www.hayward.com
092511 RevA
Chlorine Generator for Inground
Swimming Pools up to 30,000 gallons
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS