Hayward Salt & Swim 3C Salt & Swim 3C Installation Quick Start Guide

Salt & Swim

TM

3C

Installation Quick Start

Pool is less than 30,000 gallons

You have acquired an SAS-CELL salt cell (sold separately)

There is at least 10 inches of straight pipe in the return piping after all installed equipment (and

the pipe is at least 2 inches off of the ground) to install the Cell Vessel

The Control Box will be mounted within 3 feet of a 120V GFCI outlet

The Control Box will be mounted within 15 feet of the installed Cell Vessel

The Control Box will be installed at least 10 feet away from the pool.

Pool plumbing is 1½” or 2” PVC (If black polyethylene pipe is used, see manual)

You have a saw suitable for cutting PVC

You have tools for mounting the Control Box (drill, drill bits, screwdriver)

You have a permanent marker to mark the PVC pipe

You have balanced your pool chemistry and have 3200ppm salt in your pool (see Chemistry

Quick Start Guide)

Read this entire Quick Start Guide

Remove power to filter pump

Drain water from pool piping

Verify that all parts are included in the box

You are wearing safety glasses and have read the safety precautions in the owner’s manual

Before you begin

Overview

WWW.HAYWARD.COM

855-429-9274

Pre-Installation Checklist

Installation Preparation

Turn Over

Spread out parts on ground

2” Nut Assembly (2)

1.5” Nut Assembly (2)

Control Box

Screws

Strap Wrench

Compression

Ring

Collar

STEP 1:

Mount Control Box

Mount the Control Box to a wall or post within 3 feet of a GFCI outlet, making sure that the cord will

reach. The Control Box will also have to be mounted within 15 feet of the Cell Vessel as shown in the

Overview.

Use the included Mounting Template to help locate the mounting holes and fasten the Control Box to the

intended surface.

Control Box

Mounting

Template

Cell Cap & Cord

Cell Vessel

Cutting Template

Grease

Retaining Nut

Cell Vessel

Gasket (2)

SAS-CELL

(sold separately)