Hayward Spa Heaters Owners Manual

Hayward Spa Heaters Manual

Get Hayward Spa Heaters PDF manuals and user guides View all Hayward Spa Heaters manuals
Add to My Manuals
Save this manual to your list of manuals

Hayward Spa Heaters manual content summary:

  • Hayward Spa Heaters | Owners Manual - Page 1
    13024800 REV C Owner's Manual 06/2010
  • Hayward Spa Heaters | Owners Manual - Page 2
  • Hayward Spa Heaters | Owners Manual - Page 3
    in Combination with Solar or Gas Heaters 10 Using an External Controller 11 Electrical Connections 12 Wiring Diagram 13 Service Analyzer Control 14 Operation 15 Caring for your Pool Heater 16 Initial Startup 17 Meaning of Display Codes 18 Troubleshooting 19 Requesting Assistance
  • Hayward Spa Heaters | Owners Manual - Page 4
    are of superior quality, which presents you with an effective, state-of-the-art technology heat pump. Compared to other types of pool heaters, such as gas or oil-fired, the HAYWARD pool heat pump has a lower heating capacity on a BTU/hr basis. Therefore, it needs to operate for a longer time
  • Hayward Spa Heaters | Owners Manual - Page 5
    number. Model Number Serial Number Purchase Date Dealer Name Dealer Address Dealer Phone Keep this book and the sales slip together in a safe place for future reference. Service can now be obtained by calling these phone numbers. CANADA: 1 888 238-7665 USA: 1 908 355-7995 Owner's manual 3
  • Hayward Spa Heaters | Owners Manual - Page 6
    General Safety Instructions We care for our customers We have provided important safety messages in this manual and on your heater. Always result in material damage, particularly to the product, up to the destruction of part or all of the product. WARNING The WARNING sign denotes a hazard. It calls
  • Hayward Spa Heaters | Owners Manual - Page 7
    clearances needed for proper operation and heating. CAUTION ! Proper pool chemistry is vital to the life of your heater. Pay particular attention to the total alkalinity and TDS. It is highly recommended that you have your pool chemistry checked often by an independent pool store. Owner's manual 5
  • Hayward Spa Heaters | Owners Manual - Page 8
    Instructions ATTENTION!!! CONSUMER KIT LOCATED BEHIND FRONT PANEL Location The placement of the pool heater is very important in keeping installation costs to a minimum while providing for maximum efficiency of operation, as well as allowing adequate access for service and maintenance. The pool
  • Hayward Spa Heaters | Owners Manual - Page 9
    ? IMPORTANT The piping sequence is as follows: pool > pool pump > filter > heater > check valve > chemical feeder > pool. Automated chlorine distribution systems, if used, must be placed downstream of the heater to minimize harm to the pool equipment. Use rigid PVC piping if possible (SCH40 or SCH80
  • Hayward Spa Heaters | Owners Manual - Page 10
    pool, the light, the pump, the filter (if made out of metal), the heater, any automatic chlorine generator, and any other metal or electrical equipment. On some older pools, this substructure bond wire may not exist. In these cases, a 6 to 8 foot solid copper rod must be driven into the ground near
  • Hayward Spa Heaters | Owners Manual - Page 11
    Bonding and Plumbing diagram Fig. 2 Chemical feeder Heat Pump Fig. 3 Owner's manual 9
  • Hayward Spa Heaters | Owners Manual - Page 12
    with Solar or Gas Heaters If you are installing a heat pump in combination with any other type of heating device, please call the HAYWARD service department at (908) 355-7995. We will advise you of installation practices that will help keep your warranty valid. Other pool heaters, such as gas-fired
  • Hayward Spa Heaters | Owners Manual - Page 13
    mode on the main menu External mode: • Open contact = POOL mode • Closed contact = SPA mode Control using a switch To control the board using an external switch, follow these steps : • Turn on the heat pump. • Set POOL mode to OFF. • Set SPA mode to the desired temperature. • Access the setup menu
  • Hayward Spa Heaters | Owners Manual - Page 14
    is located on the lid of the control box as well as in this manual. Power requirements 240 V, 1 PH, 60 Hz Look at the name plate located on the heat pump to know the required amperage. Please refer to your local electrical code for additional wiring requirements. Fig. 5 L1 L2 Ground 12 Owner
  • Hayward Spa Heaters | Owners Manual - Page 15
    Brown FAN CAP CAP S COMPRESSOR R C Yellow Yellow HGD H/C 24 VAC PS Yellow 24 Vac Red Brown Remote switch Pool (opened) Spa (closed) Black Blue 24 Vac transformer Orange (240 Vac) or Red (208 Vac) 24 Vac compressor contactor L1 L2 Ground 208 / 230 Vac, 60 Hz 1 Phase Wiring Diagram
  • Hayward Spa Heaters | Owners Manual - Page 16
    Service Analyzer Control The control panel is factory set to display the temperature in Fahrenheit degrees. Celsius or Fahrenheit mode Temperature and parameter display raise the desired temperature or to change parameters To lower the desired temperature or to change parameters 14 Owner's manual
  • Hayward Spa Heaters | Owners Manual - Page 17
    using the down arrow . To select the pool or spa mode The unit can keep two temperature settings in memory: one for pool mode (max: 95°F/35°C), and the other for spa or SPA. Once the heating mode has been programmed, it will be displayed for five seconds, and will then return to the actual pool water
  • Hayward Spa Heaters | Owners Manual - Page 18
    Caring for your Pool Heater How to protect your pool heater 16 Owner's manual
  • Hayward Spa Heaters | Owners Manual - Page 19
    the pool pump is activited. Then, you will need to set the water temperature you desire. The fan will immediately start. The compressor will start after a 3 to 4-minute delay. When the compressor is running, the HEATING/CHAUFFAGE indicator located on the right (see "Service Analyzer Control," p. 13
  • Hayward Spa Heaters | Owners Manual - Page 20
    down your pool heater. The pool pump will also be stopped for protection if the unit's internal time clock feature is used. If LP or LP3 occurs you should call for service. HP & HP3 Low water flow to the unit or faulty high pressure control. Check water flow. Backwash filter and/or heater. The unit
  • Hayward Spa Heaters | Owners Manual - Page 21
    Troubleshooting The pool heater is not running. Heat pump control set to OFF. Desired water temperature heat pump. The heater is displaying "flo" and it will not start. Pool pump is not running. Filter is dirty, restricting the water flow. Turn the pool pump on. Backwash and clean filter. The
  • Hayward Spa Heaters | Owners Manual - Page 22
    coil without additional nozzel attachment. Do not use pressurized water as it can damage the coil and void warranty. Evaporator restricted due to improper location (see "Location", p.6). Restricted water flow. Adjust water flow. Note: If your pool heater does not operate for reasons other than
  • Hayward Spa Heaters | Owners Manual - Page 23
    of the problem, your heater's complete model and serial number, and the purchase date (see p. 3). This information will help us respond properly to your request. Keep a copy of the sales receipt showing the date of purchase. Proof of purchase will assure you warranty service. Owner's manual 21
  • Hayward Spa Heaters | Owners Manual - Page 24
    can accumulate on the evaporator. You can easily remove it by using a non-pressured water spray without damaging the small aluminum fins. been drained. It is recommended to cover the heat pump to prevent snow from getting inside. A protective winter cover is also offered by your retailer. 22
  • Hayward Spa Heaters | Owners Manual - Page 25
    Hayward® Heat Pump Pool Heater Limited Warranty The HAYWARD heat pump pool heater is warranted to be free of defects in materials and workmanship for a period of two (2) years for parts and (1) one year for labor. In the state of Florida, warranty labor is covered for (2) years. This warranty is
  • Hayward Spa Heaters | Owners Manual - Page 26
    International Warranty The HAYWARD heat pump pool heater is warranted to be free of defects in materials and workmanship for a period of one (1) year. The compressor is warranted for two (2) years, and the titanium tube component of the heat exchanger has a ten (10) year warranty. The above coverage
  • Hayward Spa Heaters | Owners Manual - Page 27
  • Hayward Spa Heaters | Owners Manual - Page 28
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
OWNER’S Manual
06/2010
13024800 REV C