Hayward TriStar® VS Owners Manual
Hayward TriStar® VS Manual
 |
View all Hayward TriStar® VS manuals
Add to My Manuals
Save this manual to your list of manuals |
Hayward TriStar® VS manual content summary:
- Hayward TriStar® VS | Owners Manual - Page 1
models. Use of this control with any other pump model will void warranty. Refer to TriStar Owner's Guide (IS3200) for all applicable pump installation, operation, and troubleshooting information. SAVE THIS INSTRUCTION MANUAL HAYWARD POOL PRODUCTS 620 DIVISION STREET ELIZABETH, NJ 07207 (908) 351 - Hayward TriStar® VS | Owners Manual - Page 2
NEC). Use of non-Hayward replacement parts voids warranty. ATTENTION INSTALLER - THIS MANUAL CONTAINS IMPORTANT INFORMATION ABOUT THE INSTALLATION, OPERATION, AND SAFE USE OF THIS PUMP THAT MUST BE FURNISHED TO THE END USER OF THIS PRODUCT. FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS COULD RESULT IN - Hayward TriStar® VS | Owners Manual - Page 3
of electric shock, see installation instructions and consult a professional electrician on how to bond pump. Also, contact a licensed electrician the "Pipe Sizing Chart" found at the bottom of page 5 of the TriStar Owner's Guide (IS3200). - Never use pool or spa if any suction outlet component is - Hayward TriStar® VS | Owners Manual - Page 4
Before servicing pool and spa water circulation system, all system and pump controls must be in off position and filter manual air manual contains information for the proper installation and operation of the Hayward TriStar Energy Solution Variable Speed Pump Control. The instructions in this manual - Hayward TriStar® VS | Owners Manual - Page 5
TriStar Owner's Guide (IS3200) for all applicable pump installation, operation, and troubleshooting (NEC). Control and pump MUST be permanently connected pump and control are being used to replace an existing pump heat pump, or booster pump) that requires the filter pump to speed pump is operating at - Hayward TriStar® VS | Owners Manual - Page 6
TriStar Variable Speed Pump Control ____ Page 6 of 16 Installation Notes 1. TURN OFF THE ELECTRICAL POWER AT THE CIRCUIT BREAKER. 2. Find a location for the SP3220VSC on a vertical flat surface, out of the direct sunlight, which will not be flooded, and above the pump. This location must be - Hayward TriStar® VS | Owners Manual - Page 7
TriStar Variable Speed Pump of pump pump runs according to prime mode selected, and defaults to P2. Timer enabled: pump remains stopped until system time reaches Timer-On setting. Use 1 - 6 buttons to switch pump pump speed within predefined range. *PRIME MODE* (when timer is disabled) *PUMP - Hayward TriStar® VS | Owners Manual - Page 8
TriStar Variable Speed Pump Control ____ Page 8 of 16 VARIABLE SPEED INTERFACE - INITIAL SETUP NOTES: 1) When power is applied to the system for the first time, or if initial setup override is engaged, the user will have to set the system language, clock, and prime mode before the pump the pump - Hayward TriStar® VS | Owners Manual - Page 9
TriStar Variable Speed Pump Control ____ Page 9 of 16 VARIABLE SPEED INTERFACE - INSTALLER SETUP CHART Event Normal operation - any mode except prime Timer Disable. Pressing 6 (OK) causes *TIMER SAVED! system to store this option. WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward TriStar® VS | Owners Manual - Page 10
TriStar Variable Speed Pump SETUP function This menu allows the user to define the pump speed and duration for each preset, which should be for currently displayed mode number causes desired pump speed to be set within predefined range. stop the pump during is set the same as above. peak - Hayward TriStar® VS | Owners Manual - Page 11
TriStar Variable Speed Pump Control ____ Page 11 of 16 SETUP mode: RANGE SETUP function This menu allows the For example, user stops on preset user to define the 6 (Maximum Flow). range of pump range is set the same as above. WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward TriStar® VS | Owners Manual - Page 12
TriStar Variable Speed Pump Control ____ Page Check configuration and proceed to Stop Mode. System enters Stop Mode until HAYWARD POOL&SPA RTC4 reaches Timer On time, or *VERSION 1.27* the where *P4 is manually selected preset which overrides the current sequence step) WWW.HAYWARDPOOL.COM - Hayward TriStar® VS | Owners Manual - Page 13
reached, at which time it will prime and proceed through the steps defined in the Sequencer menu. The pump will stop when the system reaches the Timer-OFF time. The pump may be manually stopped by pressing the 5 and 6 buttons simultaneously for more than 5 seconds. Pressing any preset button after - Hayward TriStar® VS | Owners Manual - Page 14
Troubleshooting ATTENTION - Refer to TriStar Owner's Guide (IS3200) for all applicable pump installation, operation, and troubleshooting selected user mode. When *MANUAL STOP* is selected, this Hayward Pool Products, 2007 All rights reserved. WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE - Hayward TriStar® VS | Owners Manual - Page 15
Speed Pump Control ____ Page 15 of 16 PRODUCT REGISTRATION (Retain For Your Records) DATE OF INSTALLATION INITIAL PRESSURE GAUGE READING (CLEAN FILTER PUMP MODEL SP322063EEV HORSEPOWER 2.0 FRHP (2.7 THP) FILTER MODEL SERIAL NUMBER WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE - Hayward TriStar® VS | Owners Manual - Page 16
TriStar Variable Speed Pump Control ____ Page 16 of 16 HAYWARD® LIMITED WARRANTY This control was inspected before shipment from our plant. To original purchasers of this control, Hayward Pool Products, 620 Division Street, Elizabeth, New Jersey, warrants its products to be free from defects in
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
 |
 |
P/N: IS3220VSC
Rev:
B
__________________________________________________________________________________________
OWNER’S MANUAL
INSTALLATION, OPERATION, & PARTS
TriStar
Energy Solution
TM
Variable Speed Pump Control
The Hayward TriStar Pump is specifically engineered for the demanding requirements of today’s in-ground swimming pool/spa that is
equipped with large capacity filters, heaters, and pool cleaning equipment.
The TriStar is a self-priming pump that includes an
improved seal and impeller design that will provide many years of efficient, dependable, corrosion-free service.
The advanced design
provides superior performance while reducing maintenance requirements.
NOTE -
To prevent potential injury and to avoid
unnecessary service calls, read this manual carefully and completely.
WARNING
–
The TriStar ES (Energy Solution) variable speed pump control is designed for use only with
Hayward SP322063EEV 2.7 THP 3 phase pump.
Do not use with any other pump models.
Use of this control with any other pump
model will void warranty.
Refer to TriStar Owner’s Guide (IS3200) for all applicable pump installation, operation, and
troubleshooting information.
SAVE THIS INSTRUCTION MANUAL
HAYWARD POOL PRODUCTS
620 DIVISION STREET
ELIZABETH, NJ
07207
(908) 351-5400
WWW.HAYWARDPOOL.COM