Hayward W3AQ-TROL-RJ AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09
Hayward W3AQ-TROL-RJ Manual
 |
View all Hayward W3AQ-TROL-RJ manuals
Add to My Manuals
Save this manual to your list of manuals |
Hayward W3AQ-TROL-RJ manual content summary:
- Hayward W3AQ-TROL-RJ | AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09 - Page 1
092745 RevB AquaTrol® Above Ground Pool Chlorine Generator Owner's Manual Contents Introduction 1 Water Chemistry 2 Controls 7 Installation 9 Troubleshooting............13 W3AQ-TROL-RJ W3AQ-TROL-RJ-TL W3AQ-TROL-HP W3AQ-TROL-HP-TL Hayward Pool Products 620 Division Street, Elizabeth NJ 07207 - Hayward W3AQ-TROL-RJ | AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09 - Page 2
this terminal must be connected to the grounding means provided in the electric sup- ply service panel with a continuous copper wire equivalent in size to the circuit conductors supplying the product under unsafe conditions. • SAVE THESE INSTRUCTIONS USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward W3AQ-TROL-RJ | AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09 - Page 3
when the -RJ version is ordered. Similarly, the electrical connections may be made via 120V/15A "straight blade" linecord and receptacle (standard AquaTrol version, no option designation) or may be made via a 120V/20A "twist lock" linecord and receptacle when the -TL version is ordered. W3AQ-TROL-HP - Hayward W3AQ-TROL-RJ | AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09 - Page 4
Institute (NSPI). The only special requirement for the AquaTrol is the salt level and stabilizer. It is important to maintain sure to tell the pool store that you are using an AquaTrol chlorine generator. Saturation index The saturation index (Si) relates to USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward W3AQ-TROL-RJ | AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09 - Page 5
is low, determine the number of gallons in the pool and add salt according to the chart on page 4. A low salt level will reduce the efficiency of the AquaTrol® and result in low chlorine production. A high salt level can cause the AquaTrol to shutdown and may begin to give a salty taste to your pool - Hayward W3AQ-TROL-RJ | AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09 - Page 6
4 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward W3AQ-TROL-RJ | AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09 - Page 7
Stabilizer (Cyanuric Acid) Always check stabilizer (cyanuric acid), when checking salt. These levels will most likely decline together. Use the chart below to determine how much stabilizer must be added to raise the level to 80 ppm. 5 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward W3AQ-TROL-RJ | AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09 - Page 8
"0" (down) - pump OFF Main Switch AUTO: For normal operation, the Main Switch should be left in the AUTO position. In this position the AquaTrol® will produce chlorine according to the "Desired Level %" adjustment setting for the entire filtering/pumping cycle. SUPER CHLORINATE: When you have an - Hayward W3AQ-TROL-RJ | AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09 - Page 9
When illuminated, the flow switch has detected no flow and the AquaTrol® has stopped generating chlorine. A flashing LED indicates a 15/60 second time delay period. TEST SALT LEVEL When flashing, the salt level is low (below 2700ppm) and AquaTrol is generating at low efficiency. When illuminated - Hayward W3AQ-TROL-RJ | AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09 - Page 10
AquaTrol System To maintain maximum performance, it is recommended that you open and visually inspect the cell every 3 months or after cleaning your filter. The AquaTrol Servicing and Cleaning the AquaTrol Cell Turn off power to the AquaTrol AquaTrol electrolytic cell and flow detection switch will - Hayward W3AQ-TROL-RJ | AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09 - Page 11
pool, per manufacturers instructions. This ensures a quick, troublefree transfer to the AquaTrol system. Mounting the AquaTrol Control The AquaTrol is contained in a . Do not mount the AquaTrol in a panel or tight enclosed area. AquaTrol (W3-AQ-TROL-HP) 9 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward W3AQ-TROL-RJ | AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09 - Page 12
Plumbing The cell and flow switch (not used on -RJ systems) are plumbed in the return line to the pool. Install after (downstream) all the pool equipment (filter, heater, solar, etc.). The kit included in the AquaTrol provides the necessary plumbing components for either 2" (51mm) rigid PVC piping - Hayward W3AQ-TROL-RJ | AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09 - Page 13
electrical codes. The AquaTrol has been designed to easily wire into typical above ground pool systems. To provide safe operation, the AquaTrol must be properly fault interrupter. See diagram below. AquaTrol (W3AQ-TROL-XX) AquaTrol (W3AQ-TROL-XX-TL) 11 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward W3AQ-TROL-RJ | AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09 - Page 14
is located outside, on the bottom of the enclosure. Electrolytic Cell and Flow Switch The cell and flow switch plug into connectors on the AquaTrol electronics unit. Note that return jet units (-RJ option) will NOT have a flow switch. See diagram below. 12 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward W3AQ-TROL-RJ | AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09 - Page 15
for the remainder of the current pump cycle or 24 hours, whichever comes first. 5. "No Flow" LED illuminated The AquaTrol® has sensed a no flow condition and has stopped generating chlorine. Check that the flow switch is plugged into the connector on the bottom of the control unit and that the - Hayward W3AQ-TROL-RJ | AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09 - Page 16
salt and the "Inspect Cell" LED is still illuminated, the cell may be worn and need replacement. 10. Possible causes of little or no free chlorine residual - AquaTrol switch in OFF position. - Desired Level % adjustment setting is too low. - Low stabilizer (Cyanuric Acid). - Filter pump switched - Hayward W3AQ-TROL-RJ | AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09 - Page 17
15 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward W3AQ-TROL-RJ | AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09 - Page 18
in materials and workmanship. Hayward warrants all accessories and replacement parts for the above-identified pool automation and chlorination products for a period of one (1) year. Accessories also include remotes, actuators, base stations, temperature sensors, flow switches and chemistry probes - Hayward W3AQ-TROL-RJ | AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09 - Page 19
17 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS - Hayward W3AQ-TROL-RJ | AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09 - Page 20
For further information or consumer technical support, visit our website at www.hayward.com Hayward is a registered trademark and AquaTrol is a trademark of Hayward Industries, Inc. © 2019 Hayward Industries, Inc. All other trademarks not owned by Hayward are the property of their respective owners.
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
 |
 |
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
AquaTrol
Above Ground Pool Chlorine Generator
Owner’s Manual
W3AQ-TROL-RJ
W3AQ-TROL-RJ-TL
W3AQ-TROL-HP
W3AQ-TROL-HP-TL
Contents
Introduction
....................
1
Water Chemistry
..............
2
Controls
..........................
7
Installation
.....................
9
Troubleshooting
............
13
Hayward Pool Products
620 Division Street, Elizabeth NJ 07207
Phone (908)-355-7995
www.hayward.com
092745 RevB
®