HealthRider Aire Strider E60 Elliptical English Manual - Page 5

ASSEMBLY Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included allen wrenches, assembly requires a phillips screwdriver , two adjustable wrenches , a rubber mallet , and pliers . As you assemble the elliptical exerciser, use the drawings below to identify the small parts used for assembly. The number in parenthesis below each drawing is the key number of the part, from the PART LIST on pages 24 and 25. The number following the key number is the quantity used for assembly. Note: Some small parts may have been pre-assembled. If a part is not in the parts bag, check to see if it has been pre-assembled. M6 Washer (64)-2 M8 Washer (66)-2 Torque Washer M10 Split M8 Nylon Jam M10 Nylon (113)-2 Washer (57)-3 Nut (86)-6 Locknut (89)-4 M6 x 16mm Patch Screw (76)-4 M6 x 48mm Flat Head Screw (83)-4 M8 x 63mm Bolt Set (65)-2 M8 x 19mm Patch Screw (111)-2 M10 x 25mm Button Screw (114)-3 M4 x 16mm Round Head Screw (96)-1 M4 x 16mm Screw (98)-4 M10 x 92mm Carriage Bolt (63)-2 M10 x 105mm Carriage Bolt (115)-2 M8 x 42mm Button Bolt (85)-4 M8 x 35mm Button Bolt (105)-2 1. Identify the Front Stabilizer (8), which has Wheels (109) attached to the front. While another person lifts the front of the Frame (1), attach the Front Stabilizer to the Frame with two M10 x 92mm Carriage Bolts (63) and two M10 Nylon Locknuts (89). While another person lifts the rear of the Frame (1), attach the Rear Stabilizer (not shown) to the Frame with two M10 x 105mm Carriage Bolts (not shown) and two M10 Nylon Locknuts (not shown). 1 63 5 109 8 89 1