HealthRider H130t Treadmill English Manual
HealthRider H130t Treadmill Manual
 |
View all HealthRider H130t Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
HealthRider H130t Treadmill manual content summary:
- HealthRider H130t Treadmill | English Manual - Page 1
Del. Azcapotzalco Mexico D.F., C.P. 02770 R.F.C. CMA-910911-9LO Tel. 5899 12 00 www.iconservice.com Electrical Specifications: 120V ~ 60 Hz Type Y CAUTION Read all precautions and instructions in this manual before using this equipment. Save this - HealthRider H130t Treadmill | English Manual - Page 2
YOU BEGIN 5 ASSEMBLY 6 OPERATION AND ADJUSTMENT 11 HOW TO FOLD AND MOVE THE TREADMILL 21 TROUBLESHOOTING 22 EXERCISE GUIDELINES 25 PART LIST 26 EXPLODED DRAWING 28 ORDERING shown. Note: The decals may not be shown at actual size. HealthRider is a registered trademark of ICON IP, Inc. 2 - HealthRider H130t Treadmill | English Manual - Page 3
manual and all warnings on your treadmill before using your treadmill or persons with pre-existing health problems. suppressor into a grounded circuit capable treadmill if the power cord or plug is damaged, or if the treadmill is not working properly. (See TROUBLESHOOTING on page 22 if the treadmill - HealthRider H130t Treadmill | English Manual - Page 4
procedures described in this manual. Never remove the motor hood un- less instructed to do so by an authorized ser- vice representative. Servicing other than the procedures in this manual should be performed by an authorized service representative only. 26. This treadmill is intended for in - HealthRider H130t Treadmill | English Manual - Page 5
HealthRider® H130T treadmill. The H130T treadmill offers a selection of features designed to make your workouts at home more effective and enjoyable. And when youʼre not exercising, the treadmill can be folded front cover of this manual. Before reading further, please review the drawing below and - HealthRider H130t Treadmill | English Manual - Page 6
of the part, from the PART LIST near the end of the manual. The number after the parentheses shows the quantity needed for assembly. Note the treadmill onto its left side as shown. Partially fold the Frame (55) so that the treadmill is more stable. Do not fully fold the Frame until the treadmill - HealthRider H130t Treadmill | English Manual - Page 7
2. Insert an Extension Leg (97) into the Base (85) as shown; if necessary, use a rubber mallet to fully insert the Extension Leg. Next, hold two Extension Leg Nuts (10) in the bottom of the Extension Leg, and tighten two 5/16" x 2" Bolts (2) with two 5/16" Star Washers (9) into into the top of the - HealthRider H130t Treadmill | English Manual - Page 8
5. With the help of a second person, carefully tip the treadmill onto its right side. Partially fold the Frame (55) so that the treadmill is more stable. Do not fully fold the Frame until the treadmill is completely assembled. Attach two Base Pads (81) to the Base (85) with two #8 x 1" Tek Screws - HealthRider H130t Treadmill | English Manual - Page 9
Leg Cover with three #8 x 3/4" Screws (6) and two #8 x 2 1/4" Screws (7). Be careful not to overtighten the Screws. With the help of a second person, carefully tip the treadmill down so that the Base (85) is flat on the floor. 8 82 85 6 111 7 9. With the help of a second person, hold the console - HealthRider H130t Treadmill | English Manual - Page 10
Assembly with the bracket. Lower the Frame (55) (see HOW TO LOWER THE TREADMILL FOR USE on page 21). 55 11 108 3 76 Large Barrel 85 11 3 13. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key in a secure place; the hex key is used to - HealthRider H130t Treadmill | English Manual - Page 11
the surge suppressor into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. IMPORTANT: The treadmill is not compatible with GFCI-equipped outlets. This product is for use on a nominal 120-volt circuit, and has a grounding plug that looks - HealthRider H130t Treadmill | English Manual - Page 12
six weight loss workouts. Each workout automatically controls the speed and incline of the treadmill as it guides you through an effective workout. You can even create your own custom workouts and save INFORMATION MODE on page 20. For simplicity, all instructions in this manual refer to miles. 12 - HealthRider H130t Treadmill | English Manual - Page 13
will be selected and a track will appear in the matrix. If a workout has been selected, press the Manual Control button. IMPORTANT: The console features a display demo mode, designed to be used if the treadmill is displayed in a store. If the displays light as soon as you plug in the power cord and - HealthRider H130t Treadmill | English Manual - Page 14
incline buttons. Note: After you press the buttons, it may take a moment for the treadmill to reach the selected incline setting. 5. Follow your progress with the matrix and the displays. The matrix-When the manual mode is selected, the matrix will show a track that represents 1/4 mile. As you - HealthRider H130t Treadmill | English Manual - Page 15
the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest setting. The incline must be at the lowest setting when you fold the treadmill to the storage position, or you may damage the treadmill. Next, remove the key from the console and put it in a secure place - HealthRider H130t Treadmill | English Manual - Page 16
setting is too high or too low at any time during the workout, you can manually override the setting by pressing the speed or incline buttons. Note: When the next segment of the workout begins, the treadmill will automatically adjust to the speed and incline settings for the next segment. 3. Start - HealthRider H130t Treadmill | English Manual - Page 17
or incline setting for the current segment is too high or too low, you can manually override the setting by pressing the Speed and Incline buttons. Note: When the current segment of the workout ends, the treadmill will automatically adjust to the speed and incline settings for the next segment. To - HealthRider H130t Treadmill | English Manual - Page 18
Segment To program a speed set- ting and an incline setting for the first segment, sim- ply adjust the speed and incline of the treadmill as desired by pressing the Speed and Incline increase and decrease buttons. Every few times a Speed button is pressed, an additional indicator will light - HealthRider H130t Treadmill | English Manual - Page 19
Start the walking belt. Press the Start button or the Speed increase button to start the workout. A moment after you press the button, the treadmill will automatically adjust to the first speed and incline settings of the workout. Hold the handrails and begin walking. Each custom workout is divided - HealthRider H130t Treadmill | English Manual - Page 20
: The console features a display demo mode, designed to be used if the treadmill is displayed in a store. While the demo mode is turned on, the decrease button. The Time display will show the total number of hours the treadmill has been used. To exit the information mode, remove the key from the - HealthRider H130t Treadmill | English Manual - Page 21
HOW TO FOLD AND MOVE THE TREADMILL HOW TO FOLD THE TREADMILL FOR STORAGE Before folding the treadmill, adjust the incline to the lowest position. If you do not do this, you may damage the treadmill when you fold it. Remove the key and unplug the power cord. CAUTION: You must be able to safely lift - HealthRider H130t Treadmill | English Manual - Page 22
TROUBLESHOOTING Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, see the front cover of this manual. PROBLEM: The power does not turn on SOLUTION: a. Make sure that the power cord is - HealthRider H130t Treadmill | English Manual - Page 23
still slows when walked on, see the front cover of this manual. PROBLEM: The console displays remain lit when you remove the key from the console SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a store. If the displays remain lit when you - HealthRider H130t Treadmill | English Manual - Page 24
PROBLEM: The walking belt is off-center or slips when walked on SOLUTION: a. If . Be careful not to overtighten the walking belt. Plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is centered. b. If the walking belt slips when walked on, - HealthRider H130t Treadmill | English Manual - Page 25
for persons over the age of 35 or persons with pre-existing health problems. The pulse sensor is not a medical device. Various factors may affect the key to achieving results. You can use your heart rate as a guide to find the proper intensity level. The chart below shows recommended heart rates - HealthRider H130t Treadmill | English Manual - Page 26
-Model No. HMTL79608.0 R1108A To locate the parts listed below, see the EXPLODED DRAWING near the end of this manual. Key No. Qty. 1 6 2 4 3 2 4 6 5 4 6 28 7 4 8 8 Star Washer Extension Leg Nut 3/8" Nut Belt Guide 1/2" Belt Guide Screw 3/8" x 1 1/2" Bolt Walking Platform Walking - HealthRider H130t Treadmill | English Manual - Page 27
Audio Wire 12" Blue Wire, 2F 8" Blue Wire, M/F 8" Green Wire, F/Ring 4" Black Wire, M/F 6" Red Wire, M/F User's Manual Note: Specifications are subject to change without notice. See the back cover of this manual for information about ordering replacement parts. *These parts are not illustrated. 27 - HealthRider H130t Treadmill | English Manual - Page 28
EXPLODED DRAWING A-Model No. HMTL79608.0 R1108A 28 63 63 53 77 99 63 93 63 14 99 79 20 12 13 16 106 15 54 100 63 63 53 19 18 63 17 63 61 62 102 60 57 27 29 39 49 77 99 64 60 62 102 39 28 61 57 11 27 13 55 32 108 76 3 79 12 11 23 56 14 99 20 92 3 - HealthRider H130t Treadmill | English Manual - Page 29
EXPLODED DRAWING B-Model No. HMTL79608.0 6 34 33 46 6 26 25 34 R1108A 11 69 74 75 6 34 58 66 59 68 31 110 21 109 22 37 36 23 94 11 96 48 107 38 23 42 65 40 11 37 19 41 87 43 24 71 71 87 71 6 51 52 23 104 35 45 71 47 71 71 44 6 29 - HealthRider H130t Treadmill | English Manual - Page 30
EXPLODED DRAWING C-Model No. HMTL79608.0 R1108A 8 4 73 48 111 113 84 82 5 88 89 88 9 6 6 2 6 81 1 97 10 30 80 8 4 81 5 1 73 85 80 2 9 8 7 7 11 91 81 1 97 11 88 5 89 88 10 6 6 81 1 7 84 91 81 83 1 30 8 5 81 1 4 30 - HealthRider H130t Treadmill | English Manual - Page 31
EXPLODED DRAWING D-Model No. HMTL79608.0 R1108A 6 67 99 6 99 99 6 105 95 99 6 72 99 6 99 86 114 103 99 98 101 6 99 6 99 6 99 121 112 6 6 6 24 99 70 115 90 50 6 116 90 90 78 117 116 115 115 120 90 118 119 78 31 - HealthRider H130t Treadmill | English Manual - Page 32
information when contacting us: • the model number and serial number of the product (see the front cover of this manual) • the name of the product (see the front cover of this manual) • the key number and description of the replacement part(s) (see the PART LIST and the EXPLODED DRAWING near the
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
 |
 |
USER'S MANUAL
CAUTION
Read all precautions and instruc-
tions in this manual before using
this equipment. Save this manual
for future reference.
Serial Number
Decal
Model No. HMTL79608.0
Serial No.
Write the serial number in the space
above for reference.
QUESTIONS?
If you have any questions, or if you
are missing parts,
please call the
telephone number listed below.
Vendor:
Comercializadora Mexico
Americana, S. de R.L. de C.V.
Av. Nextengo No. 78
Col. Santa Cruz Acayucan
Del. Azcapotzalco
Mexico D.F., C.P. 02770
R.F.C. CMA-910911-9LO
Tel. 5899 12 00
www.iconservice.com
Electrical Specifications:
120V ~ 60 Hz Type Y