HP 1050c Service Manual - Page 214
Front Panel Assembly - designjet printhead cleaner
View all HP 1050c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 214 highlights
Removal and Installation NOTE NOTE Installation of the Right Hand Cover Ensure the front panel cable and the aerosol fan cables are secured inside the right hand cover with cable clamps and retaining clips. At the rear of the right hand side chassis is a hole for the cables to go through. If the cables are not through this hole when the cover is in place on the printer the cover cannot be properly installed. Front Panel Assembly WARNING Removal 1. Remove the Printhead Cleaners (Refer to the User Guide). Switch off the printer and remove the power cable. 1. Remove the following: 1. "Right Hand Cover" see page 8-4. 2. The Front Panel Assembly and the Front-Panel Assembly Cable can be removed by releasing them from the retaining clips (item 1) and cable clamps (item 2) inside the Right Hand Cover (item 3) (Refer to Figure 2). 3 1 2 Figure 2: Front Panel C607436 8-6 HP DesignJets 1050C and 1055CM Printers Service Manual