HP 1050c Service Manual - Page 248
Installation of the Trailing Cable
View all HP 1050c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 248 highlights
Removal and Installation NOTE WARNING For the following steps, refer to Figure 37. 6. Remove the T-15 screw (item 1) from the trailing cable holder (item 2) and remove. 7. Remove two T-10 screws (item 3) from the trailing cable clamp (item 4). Remove the trailing cable clamp (item 4). Be very careful when disconnecting the Trailing Cable from the Electronics Module. Incorrect handling will damage the Trailing Cable and then it will need replacing. 8. Carefully disconnect the trailing cable from the electronics module and pull the trailing cable away from the printer. 3 4 2 1 Figure 37: Trailing Cable C607413 WARNING Installation of the Trailing Cable When reconnecting the Trailing Cable to the Electronics Module, make sure you connect it correctly as follows: 1. Start reconnecting the Trailing Cable from left to right (the longest strip will be connected to the 1st clip from the right). 2. Make sure you push the Trailing Cable in straight and not bent. Once the Trailing Cable is inserted, you should hear an audible click. 8-40 HP DesignJets 1050C and 1055CM Printers Service Manual