HP 1050c Service Manual - Page 36

System Error Codes System Error Codes NOTE Introduction System error codes are hexa-decimal based numbers generally caused by internal system errors. The following pages contain a list of system error codes and their respective descriptions and recommended corrective actions. Only try one recommended action at a time and check if the error code has disappeared. If you have an error code which is not documented in this Service Manual or you have an error which you cannot resolve, then report the error to the HP Response Center or the nearest HP Support Office. When reporting the error, have the following information ready: n Model and Serial Number of the printer. n Which firmware revision the printer is using (See Note below). Check firmware in Utilities / Statistics / Code rev. n The complete error number (See Note below). n The Service Configuration Print ⇒ Page 1-19. n The Current configuration sheet. n Which software application the customer is using (name, version, etc.). When reporting the System Error Code, make sure that you supply the full Error Code (including the last 8 numbers where applicable) and the firmware version. Without this information, HP Support Personnel cannot help you. NOTE Continuable and Non-Continuable Error Codes Some of the Error Codes are continuable, which means you can press Enter on the front-panel and continue working with the Printer. Non-Continuable Error Codes do not allow you to continue working with the Printer, in this case power the Printer OFF and ON again and see if the System Error disappears. If the Error Code reappears, then the Printer requires an on-site visit in order to resolve the problem. Even though the customer can continue working with a Continuable Error Code, an on-site visit should still be planned to troubleshoot the problem. 2-2 HP DesignJets 1050C and 1055CM Printers Service Manual