HP 1050c Service Manual - Page 51
Drop Detector not Calibrated for all Printheads. - designjet printhead replace
View all HP 1050c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
System Error Codes System Error: 0C0032 (Continuable) Problem Description: Drop Detector not Calibrated for all Printheads. Corrective Action: Try the following: n Perform the Service Station Calibration ⇒ Page 5-11. n Replace the Drop Detector Assembly ⇒ Page 8-10. n If the Error Code continues, replace the Electronics Module ⇒ Page 8-25. WARNING Only replace one component at a time and check if the error has gone before replacing another component. Using this procedure you will be able to determine exactly which component failed. System Error: 0C1000 Problem Description: Primer not Calibrated. Corrective Action: Try the following: n Perform the Service Station Calibration ⇒ Page 5-11. n Make sure that the Primer Arm is not damaged. If the Primer Arm is damaged, replace the Service Station ⇒ Page 8-8. n Replace the Electronics Module ⇒ Page 8-25. System Error: 0C1001 Problem Description: Primer Shutdown Error. Corrective Action: Try the following: n Check that the Primer Stepper-Motor Cable is NOT broken or damaged and that the Primer arm moves freely from side to side. n Replace the Service Station ⇒ Page 8-8. n If the Error Code continues, replace the Electronics Module ⇒ Page 8-25. WARNING Only replace one component at a time and check if the error has gone before replacing another component. Using this procedure you will be able to determine exactly which component failed. HP DesignJets 1050C and 1055CM Printers Service Manual 2-17