HP 1200 HP LaserJet 1200 Series - User Guide - Page 176
Troubleshooting the print server, BOOTP/DHCP Server
UPC - 637836445790
View all HP 1200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 176 highlights
Message Config By BOOTP Server or DHCP Server or RARP Server BOOTP/DHCP Server TFTP Server Config File Description Specifies how the print server obtained its IP configuration: BOOTP: Automatic configuration via a BOOTP server. BOOTP/TFTP: Automatic configuration via a BOOTP server and TFTP configuration file. DHCP: Automatic configuration via a DHCP server. DHCP/TFTP: Automatic configuration via a DHCP server and TFTP configuration file. RARP: Automatic configuration via the Reverse Address Resolution Protocol. User Specified: Manual configuration via Telnet, the printer's control panel, HP Web JetAdmin, an embedded Web server, or another method. Default IP: The default IP address was assigned. This address might not be a valid address for your network. Not Configured: The print server was not configured with IP parameters. Make sure that TCP/IP is enabled, or check for an error status. This message displays if BOOTP, DHCP, or RARP is used for TCP/IP configuration. This message specifies the IP address of the system that responds to the print server's request for automatic TCP/IP configuration over the network. Not Specified: The configuration server's IP address could not be determined or was set to zero in the response packet. This message displays during initialization while the print server attempts to obtain its TCP/IP configuration from a BOOTP or DHCP server. The temporary address of 0.0.0.0 displays. Not Specified: The configuration server's IP address could not be determined or was set to zero in the response packet. The IP address of the system where the TFTP configuration file is located. During initialization, the temporary address of 0.0.0.0 displays. Not Specified: A TFTP server has not been set. The name of the print server's configuration file. The file pathname might be truncated to fit on two lines. Not Specified: A file was not specified in the BOOTP reply from the host. 174 Chapter 11 Troubleshooting the print server EN