HP 4100n HP LaserJet 4100 Series - User Guide - Page 122

Printer messages (continued) Message Explanation or recommended action WAIT FOR PRINTER TO REINITIALIZE xx.yy PRINTER ERROR PRESS GO TO CONTINUE 13.x PAPER JAM [LOCATION] 20 INSUFFICIENT MEMORY alternates with PRESS GO TO CONTINUE 21 PAGE TOO COMPLEX alternates with PRESS GO TO CONTINUE 22 EIO x BUFFER OVERFLOW alternates with PRESS GO TO CONTINUE The RAM disk setting has been changed from the printer control panel. This change will not take effect until the printer reinitializes. If you change the mode of the external device, turn the printer off, turn the printer on and wait for the printer to reinitialize. A printer error has occurred that can be cleared by pressing GO in the printer control panel. Paper has either jammed in the printer or has been caught in a paper tray. 1. Open the top cover or tray indicated by the message. 2. Clear all paper from the area. If necessary, remove the toner cartridge, duplexer, or paper trays. 3. If the message persists, check for paper in all other areas. Caution Ensure that all jammed paper is removed before closing the cover or tray. Open and close the top cover to clear the message. See "Clearing paper jams" on page 96 for more detailed information. The printer received more data than can fit in its available memory. You might have tried to transfer too many macros, soft fonts, or complex graphics. Press GO to print the transferred data (some data might be lost), then simplify the print job or install additional memory (see "Printer memory and expansion" on page 229). The data (dense text, rules, raster or vector graphics) sent to the printer was too complex. Press GO to print the transferred data. (Some data might be lost.) Too much data was sent to the EIO card in the specified slot (x). An improper communications protocol may be in use. Press GO to clear the message. (Data will be lost.) Check the host configuration. 120 Chapter 4 - Problem solving EN