HP 4100n HP LaserJet 4100 Series - User Guide - Page 144

5 Does the printer select the proper trays, output locations, and paper handling accessories? YES ➜ For other problems, check the Contents, the Index, or the printer software help. ➜ NO The printer pulls paper from the An optional accessory is not A message other than wrong tray. working properly. READY is displayed. • See "Customizing what tray is • Print a configuration page to • Go to "Understanding used for printing" on page 68. verify that the accessory is printer messages" on • Make sure paper trays are installed properly and is page 111. correctly configured for paper functional (see "Configuration size and type (see "Loading page" on page 152). trays 2, 3, and 4" on page 47). • Configure the printer driver for Print a configuration page to see the installed accessories (see current tray settings (see the software help). "Configuration page" on • Turn the printer off, and then page 152). turn the printer on. • Make sure the tray selection (or • Verify that you are using the paper type) in the printer driver correct optional accessory for or software application is set the printer. correctly. (The printer driver and • If the optional duplexer will not software application settings duplex, check that the rear override the printer control panel output bin is closed. settings.) • If the optional duplexer will not • If you do not want to print from duplex, you might need to tray 1, remove any paper loaded install more memory (see in the tray or change the TRAY 1 "Printer memory and MODE setting to CASSETTE (see expansion" on page 229). "Customizing tray 1 operation" on page 69). By default, paper loaded in tray 1 will be printed first. • If you want to print from tray 1, but cannot select the tray from a software application, see "Customizing tray 1 operation" on page 69. 142 Chapter 4 - Problem solving EN