HP 4200n HP Jetdirect Print Servers - Administrator Guide - Page 278

Table C.1 HP Jetdirect Classic Control Panel Menu (2 of 6) Menu Item Description SSID: Choose one of the following selections: I hpsetup (default): This is the factory-default setting. It may be displayed in uppercase characters on most control panels, but is actually lowercase. I : Select from a list of SSIDs detected by the print server. I : The print server will automatically detect SSIDs and attempt to connect and authenticate on a network, starting with the SSID network with the best signal strength. I to enter a new SSID. CFG SSID: This item appears if SSID= was set. At the SSID= prompt, enter a custom SSID, one character at a time. This SSID will be added to the SSID list. If you subsequently enter a new SSID, it will overwrite the existing custom SSID. AUTH.: Choose one of the following authentication methods for your network: I OPEN (default) to select Open System I SHARED to select Shared Key I EAP to select among supported IEEE 802.1x Extensible Authentication Protocol (EAP) options that use an authentication server. See the CFG EAP menu. I PSK to select Extensible Authentication Protocol (EAP) using a Pre-Shared Key (PSK) on networks where an authentication server is not used. See the CFG PSK menu. CFG PSK: This item appears if AUTH.=PSK was set. Choose one of the following and select it: NO (default): Bypass PSK configuration. YES: Continue with PSK configuration. Enter a network pass-phrase that will be used to generate the Pre-Shared Key for EAP authentication on your network. At the PHRASE= prompt, enter a pass-phrase one character at a time. A pass-phrase must be from 8 to 63 ASCII characters in the hexadecimal range 21 through 7E (characters 0-9, a-z, A-Z and numerous special characters including ENWW The HP Jetdirect Control Panel Menu 278