HP 4200n HP Jetdirect Print Servers - Administrator Guide - Page 81

Telnet Commands and Parameters. Table 3.4 lists the available Telnet commands and parameters. Note If a parameter is supplied dynamically (for example, from a BOOTP or DHCP server), its value cannot be changed using Telnet without first setting Manual configuration. To set Manual configuration, see the ip-config command. Whenever you are manually changing an IP address, you should also reconfigure the subnet mask and default gateway at the same time. Table 3.4 Telnet Commands and Parameters (1 of 18) User Control Commands Command Description ? Displays the Help and Telnet commands. / Displays current values. menu Displays the Menu Interface for access to configuration parameters. advanced Enables the Advanced commands. Help (?) will include the Advanced commands in the list. general Disables the Advanced commands. Help (?) will not include Advanced commands (default). save Save the configuration values and exit the session. exit Exit the session. export Export the settings to a file for editing, and importing through Telnet or TFTP (this command is only supported by systems, such as UNIX, that support input/output redirection). General Settings Command Description passwd Set the administrator password (shared with the embedded Web server and HP Web Jetadmin). For example, "passwd jd1234 jd1234" sets the password to jd1234. Note that "jd1234" is entered twice for confirmation. Up to 16 alphanumeric characters may be used. When initiating the next Telnet session, you will be prompted for a user name and this password. To clear the password, enter the command without password and confirmation entries. Passwords may be cleared by a cold reset. ENWW TCP/IP Configuration 81