HP 438031-B21 HP 1:10Gb Ethernet Blade (BL-c) Switch Installation Instructions
HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Manual
UPC - 882780885165
View all HP 438031-B21 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP 438031-B21 manual content summary:
- HP 438031-B21 | HP 1:10Gb Ethernet Blade (BL-c) Switch Installation Instructions - Page 1
(BL-c) Switch Installation Instructions Overview This card contains information on how to set up the contents of the kit for your use. For more information on switch installation and to download management utilities and firmware, see the HP website (http://www.hp.com/go/bladesystem/documentation - HP 438031-B21 | HP 1:10Gb Ethernet Blade (BL-c) Switch Installation Instructions - Page 2
functionality of future firmware upgrade releases. manually enabled to use. A successful installation is indicated by a green Health LED. If the Health LED is amber or power is not applied to the switch, see the "Troubleshooting" section of the HP BladeSystem enclosure setup and installation guide - HP 438031-B21 | HP 1:10Gb Ethernet Blade (BL-c) Switch Installation Instructions - Page 3
not obtain the IP address by means of the BOOTP service, access the switch locally and configure the IP address manually. After assigning the IP address to the switch, then privileges: See the HP 1:10Gb Ethernet Blade Switch for c-Class BladeSystem Command Reference Guide for information on - HP 438031-B21 | HP 1:10Gb Ethernet Blade (BL-c) Switch Installation Instructions - Page 4
the XFP transceiver. With latch closed, be sure that the transceiver is fully seated and securely in place. Regulatory notice For complete details, see the HP 1:10Gb Ethernet Blade Switch for c-Class BladeSystem User Guide located on the HP website (http://www.hp.com/go/bladesystem/documentation).
HP 1:10Gb Ethernet Blade
(BL-c) Switch
Installation Instructions
Overview
This card contains information on how to set up the contents
of the kit for your use.
For more information on switch installation and to download
management utilities and firmware, see the HP website
).
Kit contents
•
One HP 1:10Gb Ethernet Blade Switch
•
This installation card
•
Limited warranty and material limitations documentation
Preparing for installation
IMPORTANT:
Before installing the switch, make a
record of the MAC address (printed on the MAC
address label attached to the switch). This address is
needed when configuring the switch.
1:10Gb Ethernet BL-c Switch
front panel
CAUTION:
Pressing the Reset button while the
Health LED is green resets the switch.
Item
Description
1
UID LED
2
Health LED
•
Off—Not powered up
•
Green—Powered up and all ports match
•
Amber—Indicates a problem such as a port
mismatch. For more information, see the HP
BladeSystem enclosure setup and installation guide.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The
only warranties for HP products and services are set forth in the express
warranty statements accompanying such products and services. Nothing
herein should be construed as constituting an additional warranty. HP shall
not be liable for technical or editorial errors or omissions contained herein.
Part Number 445878-001
March 2007 (First Edition)