HP 4510s Memory Modules - Linux

HP 4510s - ProBook - Celeron 1.8 GHz Manual

HP 4510s manual content summary:

  • HP 4510s | Memory Modules - Linux - Page 1
    Memory Modules User Guide
  • HP 4510s | Memory Modules - Linux - Page 2
    such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein. First Edition: April 2009 Document Part Number: 536505-001 Product notice This user guide describes features
  • HP 4510s | Memory Modules - Linux - Page 3
    Table of contents Adding or replacing memory modules Index ...10 iii
  • HP 4510s | Memory Modules - Linux - Page 4
    iv
  • HP 4510s | Memory Modules - Linux - Page 5
    is located under the keyboard. The memory capacity , unplug the power cord and remove all batteries before installing a second memory module, be sure that both memory modules are the same size. To add or replace a memory module: 1. Save your work. 2. Shut down the computer and close the display
  • HP 4510s | Memory Modules - Linux - Page 6
    7. Remove the screws from the battery area. Your computer has either 2 or 3 screws that need to be removed. NOTE: Refer to the illustration that most closely matches your computer. 2 Adding or replacing memory modules
  • HP 4510s | Memory Modules - Linux - Page 7
    8. Turn the computer display-side up, and then remove the 2 screws from the back edge of the computer. 9. Open the computer as far as possible. 10. Slide the switch cover straight back towards the display, and then remove the switch cover. 3
  • HP 4510s | Memory Modules - Linux - Page 8
    illustration that most closely matches your computer. 12. Slide the keyboard (1) towards the display assembly, and then turn the keyboard upside down (2) to expose the memory compartment. 13. If you are replacing a memory module, remove the existing memory module: CAUTION: To prevent damage to the
  • HP 4510s | Memory Modules - Linux - Page 9
    b. Grasp the edge of the memory module (2), and gently pull the module out of the memory module slot. To protect a memory module after removal, place it in an electrostatic-safe container. 14. Insert a new memory module: CAUTION: To prevent damage to the memory module, hold the memory module by
  • HP 4510s | Memory Modules - Linux - Page 10
    c. Gently press the memory module (3) down, applying pressure to both the left and right edges of the memory module, until the retention clips snap into place. 15. Turn over the keyboard (1) into the keyboard tray, and then slide the keyboard into place (2). 6 Adding or replacing memory modules
  • HP 4510s | Memory Modules - Linux - Page 11
    16. Replace the screws on the keyboard. Your computer has either 2 or 3 screws that need to be replaced. NOTE: Refer to the illustration that most closely matches your computer. 17. Slide the switch cover into place. 18. Close the computer display. 7
  • HP 4510s | Memory Modules - Linux - Page 12
    19. Replace the 2 screws on the back edge of the computer. 8 Adding or replacing memory modules
  • HP 4510s | Memory Modules - Linux - Page 13
    replaced. NOTE: Refer to the illustration that most closely matches your computer. 21. Turn the computer upside down on a flat surface, and then replace the battery. 22. Reconnect external power and external devices. 23. Turn on the computer. 9
  • HP 4510s | Memory Modules - Linux - Page 14
    Index K keyboard removing 4 M memory module removing 4 memory modules, replacing 1 S switch cover removing 3 10 Index
  • HP 4510s | Memory Modules - Linux - Page 15
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15

Memory Modules
User Guide