HP 8000f Maintenance and Service Guide: HP Compaq 8000f Elite Business PC Ultr - Page 71
System Board, Removing the Existing Optical Drive
UPC - 885631750551
View all HP 8000f manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
System Board CAUTION: Be very careful when removing or replacing the system board to prevent damaging it. 1. Prepare the computer for disassembly (Preparation for Disassembly on page 30). 2. Remove the computer access panel (Computer Access Panel on page 38). 3. Remove the front bezel (Front Bezel on page 39). 4. Remove the optical drive (Removing the Existing Optical Drive on page 46). 5. Remove the memory modules (Installing Additional Memory on page 41). 6. Remove the front fan (Front Fan on page 55). 7. Remove the hard drive (Hard Drive on page 49). 8. Remove the heat sink (Heat sink on page 58). 9. Remove the hard drive cage (Hard Drive Cage on page 53). 10. Remove the front I/O panel cage: a. Remove the screw from the right side of the cage that secures the I/O panel cage to the front of the chassis (1). b. Press the tab on right side of the cage (2), and then swing the right side of the cage away from the chassis to remove it (3). NOTE: If the cage sticks and will not come loose, press down on the top of the panel near the tab while pressing the tab. Figure 6-35 Removing the I/O panel cage 11. Remove the heat sink (Heat sink on page 58). 12. Disconnect all cables connected to the system board, noting their location for reinstallation. System Board 61