HP 800ps HP Designjet 800ps Printer - User's Guide - Page 67
Printhead Alignment, White Inkjet Paper Bond, HP Coated Paper, HP Heavyweight Coated Paper
View all HP 800ps manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Introduction Media & Ink Solutions Front Panel Printer Options Media Choice Roll Media Sheet Media Ink System Other Ink Cartridges Index Printheads Printhead Alignment You should have one of the following types of paper loaded before attempting to align the printheads: HP Bright White Inkjet Paper (Bond), HP Coated Paper, HP Heavyweight Coated Paper, HP High-Gloss Photo Paper, HP Satin Poster Paper or Plain Paper. If you try to do this with any other type of paper loaded, the printer will prompt you to load a different type of paper before letting you align the printheads. From time to time you may be required to align the printheads to ensure maximum print quality. To select Printhead Alignment manually, make sure you have the correct type of roll or sheet media loaded. There are two types of alignment: Standard which will take about 4½ minutes; and Special which takes about 11 minutes. Standard alignment is recommended for normal use and requires paper of at least A4/Letter-size, loaded in landscape mode. Special alignment should be used to correct pen to paper spacing variations which would be show by variations in vertical line quality, particularly in wide plots and fast print modes. Special alignment requires paper of at least A3/B-size, loaded in landscape mode. Two separate prints are made. Then use the following front panel menu selections to start the alignment: Select (using the keys) Then Press: 1. Ink 2. Align Printheads 3. Standard (4.5 minutes) Special (11 minutes) Enter Enter Enter Once you have made this selection the printer starts the alignment process which then takes several minutes. The printer will also automatically use the standard alignment process to align its printheads after Printhead Replacement. When the alignment procedure completes after a printhead replacement, the printer prompts you to ask if you want to run the Color Calibration procedure.