HP A4500A Basic Cable Connections: Document Change List - HP rp2400 Series of
HP A4500A - VMEbus Single Board Computer 744 Motherboard Manual
 |
View all HP A4500A manuals
Add to My Manuals
Save this manual to your list of manuals |
HP A4500A manual content summary:
- HP A4500A | Basic Cable Connections: Document Change List - HP rp2400 Series of - Page 1
the back of the server. Using the LAN Console as a System Console. If a LAN Console is to be used as a system console, first configure the Guardian Service Processor (GSP). For more information on GSP configuration, refer to the rp24xx Hardware Manual (search on rp2400) at http://docs.hp.com. Then
-
1
 |
 |
rp24xx_cable_change_list
v1
Printed in the U.S.A.
Basic Cable Connections - HP rp2400 Series of Servers
- Document Changes
The document
Basic Cable Connections - HP rp2400 Series of Servers
has been revised. See the table below.
IMPORTANT
The latest versions of these documents, and any updates to these documents, are posted under
the appropriate server at
.
Ver. 1.0
Page #
Ver. 2.0
Page #
Description of Change
2
2
Send documentation comments to http://docs.hp.com/assistance/index.html.
3
7
For detailed installation, maintenance, and technical information, refer to the
rp24xx Hardware Manual
and other documentation (search on
rp2400
) at
4
8
2.
(Amber) Attention (ATTN) LED
- When lit, indicates that a condition exists that
requires operator attention and assistance from HP Support.
NOTE:
For technical support please call your local support hotline or contact HP
at
.
5
9
NOTE:
For more information on console configuration, refer to the
rp24xx
Hardware Manual
(search on
rp2400
) at
.
Using a Secure Web Console PCI card as a System Console
. If the Secure
Web Console PCI card is to be used as a system console, first configure the
Guardian Service Processor (GSP). For more information on GSP configuration,
refer to the
rp24xx Hardware Manual
(search on
rp2400
) at
.
Then, connect an RJ45 LAN cable to the Secure Web Console PCI card installed
in an I/O card slot on the back of the server.
6
10
Using the LAN Console as a System Console
. If a LAN Console is to be used
as a system console, first configure the Guardian Service Processor (GSP). For
more information on GSP configuration, refer to the
rp24xx Hardware Manual
(search on
rp2400
) at
.
Then, connect it to the system with an RJ45 LAN cable to the RJ45 connector
labeled
10BASE-T LAN Console
connection on the back of the server.
6
10
NOTE:
[regarding connecting Power Distribution Units (PDUs) to Dedicated AC
Input Receptacles] Current requirements vary with input voltage, server
configuration, and number of power supplies installed. Refer to “System Site
Preparation” in the
rp24xx Hardware Manual
at
.