HP AG072A HP 1U Rackmount Keyboard with USB Installations Instructions
HP AG072A - 1U Rackmount Keyboard Manual
UPC - 882780282506
View all HP AG072A manuals
Add to My Manuals
Save this manual to your list of manuals |
HP AG072A manual content summary:
- HP AG072A | HP 1U Rackmount Keyboard with USB Installations Instructions - Page 1
1U Rackmount Keyboard with USB Installation Instructions About this device The HP 1U Rackmount Keyboard with USB is a rackmountable 1U keyboard with touchpad. NOTE: 1U equals 4.5 cm (1.8 in). The 1U rackmount keyboard is mounted on rails with space available to add a 1U KVM switch behind the unit - HP AG072A | HP 1U Rackmount Keyboard with USB Installations Instructions - Page 2
Installing the HP 1U Rackmount Keyboard with USB 4. Slide the brace rail assembly in between the HP 1U Adjustable Toolless Rails from the rear of the rack. NOTE: If the HP 1U Adjustable Toolless Rails do not snap into place, ensure that they align with the holes marked on the rack. The holes - HP AG072A | HP 1U Rackmount Keyboard with USB Installations Instructions - Page 3
8. Attach the cable management arm to the rear of the unit with two 6-32 screws. 9. Connect and route the cables through the cable management arm and opening in the rail. Installation is complete.
HP 1U Rackmount
Keyboard with USB
Installation Instructions
© Copyright 2006 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The
only warranties for HP products and services are set forth in the express
warranty statements accompanying such products and services. Nothing
herein should be construed as constituting an additional warranty. HP shall
not be liable for technical or editorial errors or omissions contained herein.
January 2006 (First Edition)
Part Number 408569-001
About this device
The HP 1U Rackmount Keyboard with USB is a rack-
mountable 1U keyboard with touchpad.
NOTE:
1U equals 4.5 cm (1.8 in).
The 1U rackmount keyboard is mounted on rails with space
available to add a 1U KVM switch behind the unit. The 1U
rackmount keyboard can be used with all HP 5000 and
10000 Series racks.
Kit contents
The kit contains the following:
•
HP 1U Rackmount Keyboard with USB (1)
•
M6 screws (4)
•
6-32 screws (5)
•
HP 1U Adjustable Toolless Rails (2)
•
Cable management arm with brace rail (1)
•
Lock plates (2)
•
USB cables (2)
•
PS/2 cables (2)
•
USB cable labels (4)
This kit contains extra hardware for your convenience.
Rack warning
WARNING:
To reduce the risk of personal
injury or damage to the equipment, be
sure that:
•
The leveling feet are extended to the
floor.
•
The full weight of the rack rests on the
leveling feet.
•
The stabilizing feet are attached to the
rack if it is a single-rack installation.
•
The racks are coupled together in
multiple-rack installations.
•
Only one component is extended at a
time. A rack may become unstable if
more than one component is extended
for any reason.