HP AiO400r HP Rack Rail Kit Installation Instructions (464164-001, February 20
HP AiO400r Manual
View all HP AiO400r manuals
Add to My Manuals
Save this manual to your list of manuals |
HP AiO400r manual content summary:
- HP AiO400r | HP Rack Rail Kit Installation Instructions (464164-001, February 20 - Page 1
Rail Kit installation instructions Overview This document contains instructions for installing HP rack rails into square and round hole racks for HP 1U and 2U servers. NOTE: For more information on preparing the server for installation, see the user guide that ships with the server. Kit contents - HP AiO400r | HP Rack Rail Kit Installation Instructions (464164-001, February 20 - Page 2
personnel are on hand to support the product(s) during the installation process. WARNING! Do not overload the branch circuit that provides power to the rack. The total rack load should not 1 Attach the rails to the rack columns 3. Slide the server into position on the rails (step 3 in Figures 2, - HP AiO400r | HP Rack Rail Kit Installation Instructions (464164-001, February 20 - Page 3
rack Figure 5 Secure the 1U server to the rack Figure 3 Insert the 2U server into the rack Figure 6 Secure the 2U server to the rack 5. Using the 7). Figure 4 CTO bracket location 4. Secure the server to the rack rails using thumbscrews on the server front bezel (step 4 in Figures 5, 6). Figure
HP Rack Rail Kit installation
instructions
© Copyright 1999, 2008 Hewlett-Packard Development Company,
L.P.
First edition: February 2008
The information in this document is subject to change without notice.
www.hp.com
*464164-001*
Overview
This document contains instructions for installing HP rack rails into square
and round hole racks for HP 1U and 2U servers.
NOTE:
For more information on preparing the server for installation,
see the user guide that ships with the server.
Kit contents
•
Two rack rails (left and right)
•
Mounting hardware for square and round hole racks
•
Two tie wraps
NOTE:
If mounting the server into threaded hole or telco racks, please
see
w
w
w
.r
a
c
ks
o
lu
ti
o
ns
.co
m
to purchase mounting hardware.
Important safety information
See the
Important Safety Information
document included with the server.
CAUTION:
Electrostatic discharge (ESD) can damage electronic
components. Be sure you are properly grounded (earthed)
before beginning any installation procedure.
Installation guidelines
This installation is to be performed by qualified individuals who have
knowledge of the procedures, precautions, and hazards associated with
equipment containing hazardous electrical circuits.
WARNING!
These rails, when installed, form only a shelf for the server to
rest on. The server is not attached to the rail by any other means.
Use extreme caution when pulling the server out from the rack;
it can slip and fall, causing damage to the server or injury. HP
is not responsible for any damage or injury caused by the
mishandling of the server.
Page 1