HP CP6015dn HP Color LaserJet CP6015 Series - User Guide - Page 212
TRAY <XX> EMPTY [TYPE][SIZE], Type Mismatch In Tray <XX>
UPC - 883585363018
View all HP CP6015dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 212 highlights
Table 12-1 Control-panel messages (continued) Control panel message Description Recommended action Rotating Motor To exit press STOP A component test is in progress; the Press STOP when ready to stop this test. component selected is the cartridge motor. Rotating Motor - To exit press STOP The product is executing a component test Press STOP when ready to stop this test. and the component selected is a motor. SANITIZING DISK % COMPLETE Do The hard disk is being cleaned. not power off Contact the network administrator. CLEANING DISK % COMPLETE For help press (Help button) Size mismatch in tray XX The paper in the listed tray does not match the size specified for that tray. 1. Load the correct paper. 2. Verify the paper is positioned correctly. 3. If the message persists, contact HP Support at www.hp.com/support/ cljcp6015. Sleep mode on The product is in sleep mode. A button press, No action is necessary. receipt of printable data, or an error condition will clear this message. TRAY [TYPE] [SIZE] To change size or type press (Checkmark button) To accept settings press (Back arrow) This message states the current type and size configuration of the tray. To change size or type press the checkmark button To accept settings press the back arrow . TRAY EMPTY [TYPE][SIZE] The specified tray is empty and the current Refill the tray at a convenient time. job does not need this tray to print. TRAY OPEN For help press (Help button) The specified tray is open or not closed completely. Close the tray. Type Mismatch In Tray The specified tray contains a paper type that The specified tray will not be used until this does not match the configured type. condition is addressed. Printing can continue from other trays. 1. Load the correct paper in the specified tray. 2. Verify the type configuration. Unable to store job A job cannot be stored because of a memory Install additional memory in the product. or configuration problem. Unauthorized supply in use The product is using a non-HP supply. If you believe you purchased a genuine HP supply, go to www.hp.com/go/ anticounterfeit. Any product repair required as a result of using non-HP or unauthorized supplies is not covered under warranty. HP cannot ensure the accuracy or the availability of certain features. USB ACCESSORY ERROR For help press (Help button) This message appears when a connected USB accessory draws too much power. When this happens, the ACC port is disabled and printing stops. Printing can continue. The USB device should be removed. 198 Chapter 12 Solve problems ENWW