HP D2600 HP StorageWorks Disk enclosure power UID with interconnect board repl
HP D2600 Manual
View all HP D2600 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP D2600 manual content summary:
- HP D2600 | HP StorageWorks Disk enclosure power UID with interconnect board repl - Page 1
with interconnect board replacement instructions About this document For the latest documentation, go to http://www.hp.com/support/ manuals, and select your product. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth - HP D2600 | HP StorageWorks Disk enclosure power UID with interconnect board repl - Page 2
(2) and lift away from the chassis. NOTE: A Torx tool with T-10 and T-15 ends is provided inside the enclosure chassis, on top of the I/O module housing. 7. Remove cable from the power UID board (1). WARNING! A disk enclosure fully populated is heavy. Prior to removing the enclosure from the rack - HP D2600 | HP StorageWorks Disk enclosure power UID with interconnect board repl - Page 3
Additional information HP support: http://www.hp.com/support HP resources (white papers and support documents): http:// www.hp.com/support/manuals 2. Align the interconnect board in the enclosure and secure the bezel ring and board with a T-15 screw (2 and 3). 3. Reconnect the UID cable from the
HP StorageWorks
Disk enclosure power UID with
interconnect board replacement
instructions
This document details the procedures for replacing a
failed power UID module in an HP storage enclosure.
© Copyright 2009 Hewlett-Packard Development Company, L.P.
First edition: June 2009
The information in this document is subject to change without notice.
Printed in the US
www.hp.com
*504219-001*
About this document
For the latest documentation, go to
h
t
tp://w
w
w
.hp
.co
m/su
ppo
r
t/
man
uals
, and select your product.
The information contained herein is subject to change without notice.
The only warranties for HP products and services are set forth in the
express warranty statements accompanying such products and services.
Nothing herein should be construed as constituting an additional
warranty. HP shall not be liable for technical or editorial errors or
omissions contained herein.
WARRANTY STATEMENT: To obtain a copy of the warranty for this
product, see the warranty information website:
h
t
tp://w
w
w
.hp
.co
m/
go/s
t
o
r
age
w
ar
r
an
t
y
Before you begin
Observe the following precautions when replacing a module.
CAUTION:
Parts can be damaged by electrostatic discharge. Use proper
anti-static protection. Refer to the documentation that shipped
with your system for additional information.
NOTE:
Port-colored (purple) latches on components mean the
component is hot-swappable. It can be removed and replaced
without having to power the system down.
NOTE:
Illustrations in this document may show modules or a chassis
that differ from your device. However, replacement procedures
are the same for all chassis that use this component.
The power UID and interconnect board are located on the rear of the
disk enclosure. See
Figure 1
for the location.
Figure 1 Power UID with interconnect board location
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
nl
Page 1