HP Designjet 4000 Service Manual - Page 357
Place the Media-Axis Motor Bracket in the, between the Media-Axis Motor Bracket
View all HP Designjet 4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 357 highlights
Removal and Installation To make sure that ALL the datums are met when installing the Media-Axis Motor Bracket, make sure you follow these instructions: 1. Place the Media-Axis Motor Bracket in the correct position on the Printer. Make sure you keep it pushed down (as shown in the illustration) until the first screw has been installed and fully tightened. 2. Install the first screw (T-15) in the position shown. Make sure you tighten the screw fully so that the Media-Axis Motor Bracket cannot be moved. 3. Check that there is no play (movement) between the Media-Axis Motor Bracket and the Drive Roller. If there is play, then check that the screw installed in the previous step is fully tightened. hp designjet 4000 series printer service manual 8-123