HP High Availability Disk Array 10/20 Power Supply Installation Guide - Not Or
HP High Availability Disk Array 10/20 Manual
View all HP High Availability Disk Array 10/20 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP High Availability Disk Array 10/20 manual content summary:
- HP High Availability Disk Array 10/20 | Power Supply Installation Guide - Not Or - Page 1
Hewlett-Packard Power Supply Installation Guide Hewlett-Packard power supplies are installable and replaceable. A replacement or add-on power supply must be the same type as the power supplies already installed - HP High Availability Disk Array 10/20 | Power Supply Installation Guide - Not Or - Page 2
without using the release button. Fan pack removed for clarity. It is not necessary to remove the fan pack to remove the power supplies. Figure 2. Manual Part Number A3692-90001 E0897 Copyright © 1997 Hewlett-Packard Company *PA3692-96001* A3692-96001
Hewlett-Packard Power Supply
Installation Guide
Hewlett-Packard power supplies are installable and replaceable. A replacement or add-on power supply must be the same
type as the power supplies already installed in the array.
The locations of the power supplies in the 30-slot disk arrays are shown in Figure 1.
.
Figure 1.
Install a power supply by performing the following steps. Place a check in the appropriate
o
as the step is completed.
Step 1:
Observe antistatic precautions
A power supply is shipped with an ESD kit containing:
–
ESD wrist strap
–
ESD conductive sheet
o
Ground the ESD wrist strap to any unplated metal on
the disk array chassis and fasten the strap to your wrist.
On 30-slot disk arrays, the ESD wrist strap can be
grounded to the metal edge above the rear retaining
screws.
Step 2:
Prepare to install the power supply
o
Remove the new power supply from its shipping carton
and place it on a suitable antistatic surface or the ESD
conductive sheet.
o
Press the release button on the fan pack and carefully
swing the fan pack down.
The installation or removal and replacement
MUST
be com-
pleted and the fan pack closed within two minutes or the
disk array will perform a thermal shutdown.
Power
supply
Disk array rear view