HP J9028B User Manual - Page 17
each upright., Partially install a screw 5/8-inch number 12-24 into the top hole of a pair
View all HP J9028B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Installing the Switch Installing the Switch Installation Procedure Steps 2, 3, and 4 on the next page describe a convenient method of mounting the switch in a rack by placing it on two screws that you first install in the rack. You may, instead, just hold the switch with attached brackets up to the rack and move it vertically until rack holes line up with the bracket holes and notches, then insert and tighten the four screws holding the brackets to the rack. 2. Partially install a screw (5/8-inch number 12-24) into the top hole of a pair of holes that are 0.5 inches apart in each rack/cabinet upright as shown in the illustration below. Ensure that the screws are at the same level in each upright. Partially install a screw into the top hole of a close (0.5-inch) pair on both sides of the rack 2-7