HP J9028B User Manual - Page 22
Removing the mini-GBICs, You should disconnect the network cable from the mini-GBIC before
View all HP J9028B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Installing the Switch Installation Procedure Removing the mini-GBICs: Note You should disconnect the network cable from the mini-GBIC before removing it from the switch. Depending on when you purchased your ProCurve mini-GBIC, it may have either of three different release mechanisms: a plastic tab on the bottom of the mini-GBIC, a plastic collar around the mini-GBIC, or a wire bail. To remove the mini-GBICs that have the plastic tab or plastic collar, push the tab or collar toward the switch until you see the mini-GBIC release from the switch (you can see it move outward slightly), and then pull it from the slot. To remove the mini-GBICs that have the wire bail, lower the bail until it is approximately horizontal, and then using the bail, pull the mini-GBIC from the slot. Replace the protective plastic cover on the mini-GBIC. Installing the Switch 2-12