HP KN844UA#ABA Upgrading and Servicing Guide
HP KN844UA#ABA - Pavilion Dv6693us - Turion 64 X2 2 GHz Manual
 |
View all HP KN844UA#ABA manuals
Add to My Manuals
Save this manual to your list of manuals |
HP KN844UA#ABA manual content summary:
- HP KN844UA#ABA | Upgrading and Servicing Guide - Page 1
Upgrading and Servicing Guide - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 2
,216, 4,819,098, and 4,907,093 licensed for limited viewing uses only. Other brand or product names are trademarks of their respective holders. HP supports lawful use of technology and does not endorse or encourage the use of our products for purposes other than those permitted by national copyright - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 3
or Installing an Add-in Card 17 Removing an Add-in Card 17 Installing an Add-in Card 18 Replacing the Battery 18 Upgrading and Servicing Guide iii - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 4
iv Upgrading and Servicing Guide - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 5
Guide before installing and connecting your system to the electrical power system. The Upgrading and Servicing Guide provides instructions save the system model and serial numbers, all installed options and other to open up and examine the PC. • HP recommends that you use an antistatic wrist strap - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 6
. 3 Turn on the PC and all peripherals. 4 If you installed an add-in card, install any software drivers supplied by the card manufacturer. Removing the Side Panel 1 See "Before Opening the PC" on page 1. 2 Loosen side panel. 3 See "After Closing the PC" on page 2. 2 Upgrading and Servicing Guide - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 7
the tab on the bottom of the front panel is inserted into the slot on the bottom of the chassis. 2 Guide the three small tabs (B) on each side of the front panel into the correct holes until the panel snaps into place to lock when the tab is in the lock position. Upgrading and Servicing Guide 3 - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 8
the recovery discs to load the factory-installed files. See the User's Guide for details about the recovery procedure. You can add an optical drive XP operating system. Also, make sure you have the correct software and drivers for the optical drive to work with the operating system. You can replace - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 9
" on page 3. 8 Complete the procedures to replace the side panel, and to close the PC. See "Opening and Closing the PC" on page 1. Upgrading and Servicing Guide 5 - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 10
instructions, "To remove a drive (with a removable drive cage) (select models)" on page 6. To ensure that the drive fits properly into the PC, be sure to purchase the replacement diskette drive from HP. Refer to the Warranty and Support Guide cage release tab (E). 6 Upgrading and Servicing Guide - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 11
with a fixed drive cage) (select models)" on page 7. If the drive cage is removable, follow the second set of instructions, "To install a drive (with a removable drive cage) (select models)" on page 8. To install a drive (with out through the front of the drive cage. Upgrading and Servicing Guide 7 - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 12
push the drive cage forward until it snaps into place. 8 Upgrading and Servicing Guide 6 Connect the cable to the back of the drives. 7 Complete the PC may be located inside a cage. If it is, follow the first set of instructions, "To remove a hard disk drive (with a hard disk drive cage)" on page - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 13
in the same direction, and then pull it out of the hard disk drive bracket (J). Disconnecting the Serial ATA hard disk drive cables Upgrading and Servicing Guide 9 - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 14
of each cable attached to the hard disk drive before removing the cables. Disconnecting the Parallel ATA hard disk drive data cable 10 Upgrading and Servicing Guide - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 15
drive cage)" on page 11. If your hard disk drive is not located inside a cage, follow the second set of instructions, "To replace a hard disk drive (without a hard disk drive cage)" on page 12. To replace a hard disk PC. See "Opening and Closing the PC" on page 1. Upgrading and Servicing Guide 11 - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 16
disk drive, please contact Customer-replaceable Parts Service, which is available in some countries/regions. For contact information, refer to the Warranty and Support Guide. If your PC does include a cage around the hard disk drive, use the following instructions. 12 Upgrading and Servicing Guide - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 17
hard disk drive, connect the data IDE cable end labelled Slave to the drive. Connecting the Parallel ATA hard disk drive data cable Upgrading and Servicing Guide 13 - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 18
3. 14 Complete the procedures to replace the side panel, and to close the PC. See "Opening and Closing the PC" on page 1. 14 Upgrading and Servicing Guide - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 19
front of the chassis (P). Lift the second hard disk drive out of the chassis. Disconnecting the Parallel ATA hard disk drive data cable Upgrading and Servicing Guide 15 - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 20
number of sockets depends on which model you have. To determine which type of memory module your PC uses, and for specific memory module information and specifications, go to the Web site listed in your Warranty and Support Guide and click the Support on the module.) 16 Upgrading and Servicing Guide - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 21
V current draw in a fully loaded system (one with all add-in card slots filled) must not exceed the total number of slots multiplied by 2 amps. A Phillips screwdriver is needed to remove, replace or add an add-in card. card straight out of the add-in card slot. Upgrading and Servicing Guide 17 - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 22
equivalent, type of battery. Discard used batteries according to the manufacturer's instructions. 1 Complete the procedures to prepare the PC and to remove the , read through the card manufacturer's installation instructions, and recheck all connections, including those to the card, power supply - HP KN844UA#ABA | Upgrading and Servicing Guide - Page 23
- HP KN844UA#ABA | Upgrading and Servicing Guide - Page 24
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
 |
 |
Upgrading and Servicing Guide