HP LaserJet 9040/9050 Service Manual - Page 56

Item Values Explanation FUSER MODES (HP LaserJet 9000 only) List of print-media types Configure the fuser mode that is associated with each media type. The default value for each paper type is AUTO. The fuser mode can only be changed from this menu option on the control panel. AUTO: Utilizes the optimum mode for that media type. NORMAL: Normal temperature; prints at 50 pages per minute (ppm). LOW: Low temperature; prints at 50 ppm. HIGH1: Raises the temperature, prints at 50 ppm. HIGH2: Raises the temperature; prints at 32 ppm. SPECIAL: Use this mode to print at normal speeds with a 40-second delay added to the beginning of the next job. After each 400 pages are printed, the first page of that job is printed at a slower speed in order to clean the fuser. No defects should be noticeable on the printed page. This is not a preferred setting. CAUTION If you change the fuser mode to HIGH1 or HIGH2, be sure to change it back to the default when you are done printing. Setting a paper type to HIGH1 or HIGH2 might shorten the life of some consumables, such as the fuser, and might cause other failures or jams. 40 Chapter 3 Product configuration