HP ML350 Third Fan Installation for HP ProLiant ML350 G6 Servers Fan locations

Third Fan Installation

for HP ProLiant ML350 G6 Servers

Fan locations

CAUTION:

To maintain proper cooling, all fan bays must be

populated with a fan or a fan blank.

Item

Description

1

Rear fan 1

2

Rear fan 2

3

Front fan 3

4

Front fan 4

Installing the third fan

WARNING:

Eliminate the risk of electric shock by removing all

AC power from the system before installing or replacing any non-

hot-plug hardware option to the system. Disconnect all power

cords to completely remove power from the server.

WARNING:

To reduce the risk of personal injury from hot

surfaces, allow the drives and the internal system components to

cool before touching them.

To install the component:

1.

Power down the server.

2.

Do one of the following:

o

Open or remove the tower bezel, as needed.

o

Extend the server from the rack.

3.

Remove the access panel.

4.

Remove the large redundant fan air baffle, if installed.

5.

Remove the fan blank from fan bay 3.

6.

Install the fan in fan bay 3.

7.

Install the large air baffle, if removed.

8.

Install the access panel.

9.

Do one of the following:

o

Close or install the tower bezel, as needed.

o

Slide the server back into the rack.

10.

Power up the server.

© Copyright 2010 Hewlett-Packard Development Company, L.P.

The information contained herein is subject to change without notice. The only warranties for HP

products and services are set forth in the express warranty statements accompanying such

products and services. Nothing herein should be construed as constituting an additional

warranty. HP shall not be liable for technical or editorial errors or omissions contained herein.

February 2010 (First Edition)

Part Number 610902-001