HP ML350 HP ProLiant Servers Troubleshooting Guide - Page 113

Redundant Path Failure: Multi-domain path failure

Get HP ML350 - ProLiant - G6 PDF manuals and user guides View all HP ML350 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 113 highlights

NVRAM Error: Board ID could not be read... ...(Read-Only Table failed checksum test). Unrecoverable error. Action: Contact HP support ("Contacting HP" on page 171). NVRAM Error: Bootstrap NVRAM image failed checksum test,... ...but a backup image was found and successfully restored. A system restart is needed. Action: Restart the server. NVRAM Error: Bootstrap NVRAM image failed checksum test... ...and could not be restored. This error may or may not be recoverable. A firmware update might be able to correct the error. Action: Update the controller firmware. If the update fails, contact HP support ("Contacting HP" on page 171). Physical Drive State: The data on the physical drive is being rebuilt. Action: No action is required. Normal operations can occur; however, performance will be less than optimal during the rebuild process. Physical Drive State: This drive is not supported for configuration... ...and should be disconnected from this controller. Action: Replace the physical drive with a drive supported by the controller. Redundancy State: This controller has been setup to be part of a redundant pair of controllers.... ...but redundancy is temporarily disabled. Redundancy is temporarily disabled because capacity expansion, extension, or migration is in progress. Redundancy will be enabled when this process is complete. Action: No action is required. Redundancy State: This controller has been setup to be part of a redundant pair of controllers.... ...but redundancy is disabled. Redundancy is disabled for an unknown reason. Action: Contact HP support ("Contacting HP" on page 171). Redundant Path Failure: Multi-domain path failure Action: Check the storage device I/O module and cables to restore redundant paths. Redundant Path Failure: The logical drive is degraded due to the loss of a redundant path. Action: Check the storage box I/O module and cables to restore redundant paths to the logical drive. Error messages 113

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
NVRAM Error: Board ID could not be read...
...(Read-Only Table failed checksum test). Unrecoverable error.
Action
: Contact HP support ("
Contacting HP
" on page
171
).
NVRAM
t a bac
lly restored. A system restart is needed.
NVRAM Error: Bootstrap NVRAM image failed checksum test...
...and cou
overable. A firmware update might be able to correct
the error.
Action
: Update the controller firmware. If the update fails, contact HP support ("
Contacting HP
" on page
Physica
e data on the physical drive is being rebuilt.
from this controller.
Redund
dant pair of
controllers
....
porarily disabled because capacity expansion,
extension, or migration is in progress. Redundancy will be enabled when this process is complete.
Action
: No action is required.
Redund
f a redundant pair of
control
...but redu
ing HP
" on page
171
).
dule and cables to restore redundant paths.
Redund
aded due to the loss of a
redund
ox I/O module and cables to restore redundant paths to the logical drive.
Error: Bootstrap NVRAM image failed checksum test,...
kup image was found and successfu
...bu
Action
: Restart the server.
ld not be restored. This error may or may not be rec
171
).
l Drive State: Th
Action
: No action is required. Normal operations can occur; however, performance will be less than
optimal during the rebuild process.
Physical Drive State: This drive is not supported for configuration...
...and should be disconnected
Action
: Replace the physical drive with a drive supported by the controller.
ancy State: This controller has been setup to be part of a redun
...but redundancy is temporarily disabled. Redundancy is tem
ancy State: This controller has been setup to be part o
lers
....
ndancy is disabled. Redundancy is disabled for an unknown reason.
Action
: Contact HP support ("
Contact
Redundant Path Failure: Multi-domain path failure
Action
: Check the storage device I/O mo
ant Path Failure: The logical drive is degr
ant path.
Action
: Check the storage b
Error messages 113