HP ML350 HP ProLiant Servers Troubleshooting Guide - Page 122

This system only supports 667 MHz Front Side Bus Speed Processors. One or more 800 MHz Front Side Bus Speed Processors have been initialized at 667 MHz. System Halted! Audible beeps: 1 long, 1 short Possible cause: One or more 800-MHz front side bus speed processors have been initialized at 667MHz. Action: Correct the processor configuration. Unsupported DIMM(s) found in system. - DIMM(s) may not be used Description: Unsupported memory types found in system. Action: Refer to the applicable server user guide memory requirements and replace with supported DIMMs. Unsupported PCI Card Detected Remove PCI Card from Slot Audible beeps: 2 short Possible cause: The PCI card installed in the slot referenced in the message is strictly not supported on this system. Action: Remove the card from the slot reported in the message. Unsupported power supply detected in bay X Audible Beeps: 1 long, 1 short Possible Cause: The power supply in bay X is not supported by the server. Action: Install a supported power supply in bay X. For supported power supplies, see the server documentation on the HP website (http://www.hp.com/support). Unsupported Processor Detected System will ONLY boot ROMPAQ Utility. System Halted. Audible Beeps: 1 long, 1 short Possible Cause: Processor and/or processor stepping is not supported by the current system ROM. Action: Refer to the server documentation for supported processors. If a ROM version exists that supports the processor, 1. Power down the server. 2. Insert a Systems ROMPAQ diskette containing the latest ROM version. 3. Boot the system to flash the system to the latest ROM version. Allow 15 minutes for the process to complete. Successful completion is indicated by a series of beeps of increasing pitch. USB Tape-based One button Disaster Recovery (OBDR) drive detected. Error messages 122