HP ML530 Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro
HP ML530 - ProLiant - 128 MB RAM Manual
UPC - 720591250669
View all HP ML530 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP ML530 manual content summary:
- HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 1
Microsoft Windows Server 2003 with Service Pack 1 on ProLiant servers integration note, 2nd edition Abstract...2 Introduction to Windows Server 2003 and Service Pack 1 2 Supported configurations ...2 Recommended system configuration 3 Server platforms...3 Supported software ...6 Supported storage - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 2
Server 2003 Service Pack 1 provides refinements and supplies cumulative system patches to Windows Server 2003. Supported configurations Windows Server 2003 SP1 should load and run on any ProLiant server that meets the recommended hardware configuration established by Microsoft. Carefully review - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 3
version: http://h18007.www1.hp.com/support/files/server/us/romhowto.html • Latest ROMPaq downloads: http://h18023.www1.hp.com/support/files/server/us/romtabl.html • Software and drivers: http://h18007.www1.hp.com/support/files/server/us/index.html • Windows on ProLiant support matrix: http://h10018 - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 4
greater) ProLiant DL380 G33, 4 ProLiant DL380 G43 ProLiant DL380 G4 Packaged Cluster3 ProLiant DL3853 ProLiant DL5603, 4 ProLiant DL580 ProLiant DL580 G23, 4 ProLiant DL580 G33 ProLiant DL5853 ProLiant DL7403, 4 ProLiant DL7603 ProLiant DL760 G23, 4 ProLiant ML110 ProLiant ML110 G2 ProLiant ML150 - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 5
Server platform ProLiant ML150 G2 ProLiant ML3103, 4 ProLiant ML310 G2 ProLiant ML330 ProLiant ML330 G23 ProLiant ML330e ProLiant ML350 (1 GHz) ProLiant ML350 (600, 733, 800, 866, 933 MHz) ProLiant ML350 G2 (1133 MHz and greater)3 ProLiant ML350 G33, 4 ProLiant ML350 G43 ProLiant ML350 G4p3 ProLiant - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 6
ProLiant utilities, drivers, and other value-add software and their corresponding version needed for Windows Server 2003 SP1. Table 3. Supported ProLiant value-add software Utility Minimum version Location Array Configuration Utility for Windows 2000 2.90.65.0 http://h18023.www1.hp.com/support - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 7
options Table 4 lists supported ProLiant storage options and recommended driver revisions needed to interface with Windows Server 2003 SP1. Table 4. Supported ProLiant storage options Option Driver HP 4 GB Hard Disk Drives HP 9 GB Hard Disk Drives HP 18 GB Hard Disk Drives HP 36 GB Hard Disk - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 8
Windows Server 2003 Version 7.30A Smart Array 5i Controller 6, 7 CPQCISSM.SYS Windows Server 2003 SP1 CD Yes Smart Array 5i Controller Plus CPQCISSM.SYS Windows Server 2003 SP1 CD Yes Smart Array 5302 Controller 6, 7 CPQCISSM.SYS ProLiant Support Pack for Yes Microsoft Windows Server 2003 - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 9
6 Driver Location CPQCISSM.SYS CPQCISSM.SYS CPQCISSM.SYS CPQCISSM.SYS CPQCISSM.SYS CPQCISSM.SYS CPQCISSM.SYS CPQCISSM.SYS CPQFCALM.SYS ProLiant Support Pack for Microsoft Windows Server 2003 Version 7.30A Windows Server 2003 SP1 CD Windows Server 2003 SP1 CD Windows Server 2003 SP1 CD Windows - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 10
for Yes Ultra320 SCSI Host Bus Adapter Microsoft Windows Server 2003 Version 7.30A HP 64-bit/13MHz Single Channel SYMMPI.SYS ProLiant Support Pack for Yes Ultra320 SCSI Host Bus Adapter Microsoft Windows Server 2003 Version 7.30A Note 6: Driver upgrades for many of the listed devices are - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 11
5 lists supported ProLiant network interface controllers (NICs) and driver revisions supported by Windows Server 2003 SP1. Table 5. Supported ProLiant Network Interface Controllers NIC NC3120 Fast Ethernet NC3122 Fast Ethernet NC3123 Fast Ethernet NC3131 Fast Ethernet NC3132 Fast Ethernet Upgrade - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 12
Motherboard (LOM) Microsoft Windows Server 2003 Version 7.30A HP NC7761 Gigabit Server Adapter Q57XP32.SYS ProLiant Support Pack for Yes Microsoft Windows Server 2003 Version 7.30A NC7770 Gigabit Q57XP32.SYS ProLiant Support Pack for Yes Microsoft Windows Server 2003 Version 7.30A HP - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 13
ProLiant servers, Smart Array Cluster Storage, or StorageWorks platforms integrated with HP management tools. The following products support Windows Server 2003, Enterprise Edition: ProLiant DL380 G4 Packaged Cluster, ProLiant DL380 G3 Packaged Cluster, ProLiant DL380 G2 Packaged Cluster, ProLiant - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 14
Hot Plug RAID Memory driver and utility are included in Version 7.30A and later of the ProLiant Support Pack for Microsoft Windows Server 2003: • HP ProLiant Hot-Plug Memory Configuration Utility for Windows Server 2003 • HP ProLiant Hot Plug Memory Driver for Windows Server 2003 Lights-Out - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 15
2. For the ProLiant servers listed in Table 7, obtain System Configuration Utility Version 2.58 (or later) at http://h18023.www1.hp.com/support/files/server/us/locate/1950.html and create the associated bootable diskette set. Run the utility and verify that all system configuration options conform - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 16
the proper procedures to follow when performing a clean (new) installation of the Windows Server 2003 SP1 operating system on ProLiant servers. To complete a Windows Server 2003 SP1 installation fully supported by HP, follow these steps when setting up the system. Read the following sequence - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 17
Once the OS is installed, configure the array through the Array Configuration Utility (ACU) using the PSP for Microsoft Windows Server 2003 Version 7.30A 5. Insert the Windows Server 2003 SP1 CD into the CD-ROM drive to begin installation. 6. After Windows Server 2003 SP1 has been installed, install - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 18
the OEMPreinstall flag set. [UNATTEND] DisableVirtualOemDevices=Yes 2. Ensure that any special hardware-specific drivers appropriate for your ProLiant server are available in the specified OEMFilesPath. The drivers for the supported devices may not be included on the base media. Note: These changes - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 19
is enabled in Microsoft Windows Server 2003 Service Pack 1 (SP1), it causes the HP Insight Management Agents for Windows Server 2003 and the HP ProLiant Rack Infrastructure Interface Service for Windows Server 2003 (this only affects ProLiant Server Blades) to stop running. For additional details - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 20
http://h18007.www1.hp.com/support/files/server/us/locate/6397.html CPQCISSE.SYS Version 5.42.2.32 (or later) is downloadable as follows: • Name: ProLiant Smart Array 5x and 6x Controller Driver for Windows 2000/Server 2003 • Download location: http://h18007.www1.hp.com/support/files/server/us/locate - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 21
There may be a hardware or media problem. Please check the system event log for hp.com/enterprise/downloads/WindowsServer2003KB817688-i386-ENU.exe. Then, run the executable in the Windows Server 2003 environment. ProLiant Advanced System Management Controller Driver for Microsoft Windows Server 2003 - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 22
Server 2003 on a ProLiant server that has an embedded virtual install disk, the error message listed above may be generated when using an UNATTEND.TXT file that includes the OEMPreinstall flag. The problem occurs because the Windows Server 2003 -Based Setup Utility (RBSU) for the affected server. 22 - HP ML530 | Implementing Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 23
and Install Windows Server 2003 Service Pack 1 (SP1) Web address www.hp.com/go/microsoft www.microsoft.com www.microsoft.com/technet/prodtechnol/windowsserver2003/ servicepack/default.mspx Call to action Send comments about this paper to: [email protected]. © 2005, 2006 Hewlett-Packard Development
Implementing Microsoft Windows Server 2003 with Service
Pack 1 on ProLiant servers
integration note, 2
nd
edition
Abstract
..............................................................................................................................................
2
Introduction to Windows Server 2003 and Service Pack 1
.......................................................................
2
Supported configurations
..................................................................................................................
2
Recommended system configuration
...................................................................................................
3
Server platforms
...............................................................................................................................
3
Supported software
..........................................................................................................................
6
Supported storage options
................................................................................................................
7
Supported network interface controllers
............................................................................................
11
ProLiant cluster support
.......................................................................................................................
13
PCI Hot Plug support
..........................................................................................................................
13
Lights-Out management support
...........................................................................................................
14
SmartStart installation paths
................................................................................................................
14
Pre-installation tasks
...........................................................................................................................
14
Procedures for performing a clean installation
.......................................................................................
16
Blade installation
...........................................................................................................................
16
Manual install
................................................................................................................................
16
Unattended install
..........................................................................................................................
18
Known issues and workarounds
...........................................................................................................
18
For more information
..........................................................................................................................
23
Call to action
....................................................................................................................................
23