HP N8460 Scanjet N8400 Setup and Support Guide - Page 10
Connect the power cable, Connect the USB cable - scanjet
UPC - 883585086399
View all HP N8460 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Chapter 1 NOTE: For help uninstalling the ADF, see the Care and maintenance section of the scanner User Guide, which is described in Where to get additional information. Connect the power cable 1. Use the power cable to connect the scanner to an electrical outlet. 2. Press the Power switch on the back of the scanner to the on position. NOTE: After using the scanner, press the Power Save ( ) button on the scanner front panel to put the scanner in power-save mode. You do not need to use the Power switch on the back of the scanner after the scanner is set up and operational. Connect the USB cable CAUTION: Be sure you install the HP scanning software before connecting the scanner to your computer with the USB cable. See "Install the software" on page 2. Use the USB cable that came with the scanner to connect the scanner to the computer. Connect the square end of the cable to the scanner and the rectangular end of the cable to the computer. NOTE: HP recommends using a USB port on the back of the computer for a more reliable connection to the scanner. 6 HP Scanjet N8400 series