HP NetServer LT 6000r HP Netserver LH 6000 NetRAID-3Si Config Guide for Windo

1

HP NetServer LH6000

with

NetRAID-3Si (HP Rack Storage/12)

Cluster Configuration Guide

4 October 2000

(see

Versions

at the end of this document)

Introduction

This document defines the supported HP NetServer LH6000 configurations with HP Rack Storage/12s and

Microsoft Cluster Server.

These configurations minimize single points of failure (SPOF) and provide extended

availability.

The specific configuration certified and supported by both Hewlett-Packard and Microsoft is

defined, as are other guidelines to assist you in configuring your clustered NetServers.

This guide is prescriptive;

it describes the configurations supported by HP.

Any deviance to these configurations can result in an

inoperative cluster or an operating cluster with degraded performance, hidden SPOFs, etc., and therefore will not

be supported by HP.

What's Defined in a Racked Cluster

•

Cluster

•

SPUs

•

Local and Shared Storage

•

Intra-cluster and Client LANs

•

Shared Storage Cabling

Cluster

Type of SPUs

HP NetServer LH6000

Each node must be the same model SPU, but may have different clock

speeds, main memory sizes, cache sizes, and number of CPUs.

Installation

Pedestal or racked

Number of nodes

2

Shared Storage

HP Rack Storage /12 with HP NetRAID-3Si controller and HP disks.

See

Shared Storage

below.

LANs:

Client LAN

Any that is HP and Microsoft approved.

See

Client LAN

below.

Intra-cluster

(Heartbeat) LAN

Embedded NIC with crossover cable. See

Intra-cluster LAN

below.

Power source

Direct from power mains, power conditioner or uninterruptible power

supply (UPS) using any power conditioner or UPS.

Redundant power

distribution units (PDU’s) are strongly recommended.

System software:

Navigator version

L.18.02 or later