HP NetStorage 6000 Hard Drive Replacement

HP NetStorage 6000 Manual

Get HP NetStorage 6000 PDF manuals and user guides View all HP NetStorage 6000 manuals
Add to My Manuals
Save this manual to your list of manuals

HP NetStorage 6000 manual content summary:

  • HP NetStorage 6000 | Hard Drive Replacement - Page 1
    HP NETSTORAGE 6000 Hard Drive Replacement Before You Begin: • Use only HP Hard Drives approved for your NetStorage 6000. For an up-to-date list of approved hard disk drives, please visit our web site at http://www.hp.com/support/ns6000. Drives on the approved list have custom firmware for use in
  • HP NetStorage 6000 | Hard Drive Replacement - Page 2
    one that was called into service. To rebuild a logical drive: A. Open a web browser's address or location field. B. Select Storage > Physical Drives > Actions > Rebuild Logical in the browser's address or location field. B. Select Storage > Physical Drives > Actions > Assign Hot Spares. C.
  • 1
  • 2
Hard Drive Replacement
H
P
N
E
T
S
T
O
R
A
G
E
6
0
0
0
A.
If an alarm is sounding, press the alarm-reset button
on the
front panel.
B.
Open the front panel door, and locate the blinking red LED along the
top front edge of the unit. This LED is directly above the failed unit.
C.
Use the key to unlock the drive shuttles.
D.
Loosen the shuttle thumbscrew at the base of the failed drive.
Pull forward on the thumbscrew and lift the shuttle lever.
E.
Slide the failed drive assembly forward and out of the drive bay.
Before You Begin:
•
Use only HP Hard Drives approved for your NetStorage 6000.
For an up-to-date list of approved
hard disk drives, please visit our web site at http://www.hp.com/support/ns6000.
Drives on the
approved list have custom firmware for use in your NetStorage 6000.
Do not attempt to install any
hard disk drives other than the approved drives listed at this web site as doing so may result in
system failure or loss of data.
Using non-supported hard drives may also void your warranty.
•
This replacement drive kit should not be used for expanding your system. For upgrades, use an
HP NetStorage 6000 Hard Drive Upgrade Kit.
•
To insure proper cooling of the unit, leave the failed drive in the bay until you are ready to replace it.
•
It is best to replace a hard drive when the NetStorage 6000 is operating.
D.
B.
C.
E.
Locate and Remove the Failed Drive
Parts Required:
•
1 drive (same capacity as the failed
drive)
•
Key for physically unlocking the
hard drives
•
Electrostatic protection device