HP NetStorage 6000 Network Interface Upgrade
HP NetStorage 6000 Manual
View all HP NetStorage 6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP NetStorage 6000 manual content summary:
- HP NetStorage 6000 | Network Interface Upgrade - Page 1
HP NETSTORAGE 6000 Network Interface Upgrade NOTES: • Use only HP NetStorage 6000 Network Interface Cards for upgrades. • For this upgrade, you should choose a time when end-user access is not required for the unit. Configurations supported: Any combination of one or two of the following HP NICs - HP NetStorage 6000 | Network Interface Upgrade - Page 2
Add or Remove a NIC Card A. Unplug the network cable. B. Unscrew the existing NIC and gently remove it. NOTE: If you are installing the NIC in an unused PCI slot, remove the expansion slot - HP NetStorage 6000 | Network Interface Upgrade - Page 3
cords on the back panel of the HP NetStorage unit, and plug them into your power source. C. Turn on the unit. D. Press the alarm-reset button on the front panel to turn off the alarm. The alarm sounds whenever the unit is powered on. Enter Network Information A. Follow one set of the directions - HP NetStorage 6000 | Network Interface Upgrade - Page 4
*C4480-90101* C4480-90101
Network Interface Upgrade
H
P
N
E
T
S
T
O
R
A
G
E
6
0
0
0
Configurations supported:
Any combination of one or two of the following
HP NICs is supported:
•
10/100 bT
•
Dual 10/100 bT
•
Gigabit 1000 Base SX
Each NIC port must be attached to a different subnet.
Trunking is not supported.
Parts required:
•
New NIC card
Tools required:
•
Phillips screwdriver
•
Electrostatic protection device
NOTES:
•
Use only HP NetStorage 6000 Network Interface Cards for upgrades.
•
For this upgrade, you should choose a time when end-user access is not required for the unit.
Shut Down the System
Open the Case
A.
Remove the two screws on the back of the unit that hold
the top in place.
B.
Slide the top backwards, and lift to remove.
A.
Shut down the unit using either the front panel interface
or the HP NetStorage web interface.
B.
After system shutdown is complete, turn off the power
switch on the back panel of the unit.
C.
Disconnect both power cords from the back panel of the
unit.