HP NetStorage 6000 Power Supply Replacement
HP NetStorage 6000 Manual
 |
View all HP NetStorage 6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP NetStorage 6000 manual content summary:
- HP NetStorage 6000 | Power Supply Replacement - Page 1
power supply in the unit until you are ready to install the replacement. • You can change one power supply at a time while the HP NetStorage 6000 is operating. Parts Required: • One power supply • Electrostatic protection device Locate the Failed Power Supply A. If an alarm is sounding, press the - HP NetStorage 6000 | Power Supply Replacement - Page 2
should turn green to indicate its proper operation. Order a Spare Power Supply A. You should always have a spare power supply on hand. To order a replacement, call HP Customer Care at 970-635-1000. *C4481-90102* C4481-90102
-
1 -
2
 |
 |
Power Supply Replacement
H
P
N
E
T
S
T
O
R
A
G
E
6
0
0
0
NOTES:
•
To insure proper air flow, leave the power supply in the unit until you are ready to install the
replacement.
•
You can change one power supply at a time while the HP NetStorage 6000 is operating.
Locate the Failed Power Supply
Remove the Failed Power Supply
A.
If an alarm is sounding, press the alarm-reset button
on the front panel.
B.
Locate the blinking red LED on the back panel. This LED identifies
the failed power supply.
NOTE:
If no LED is flashing, then the power supply may not be
fully seated in the unit. Make sure the power supply latch is in its
fully upward position.
A.
Push down on the failed power supply’s latch, and carefully pull
the power supply out of the unit as shown.
Parts Required:
•
One power supply
•
Electrostatic protection device