HP OMEN GA1-1000 Quick Setup Guide

HP OMEN GA1-1000 Manual

HP OMEN GA1-1000 manual content summary:

  • HP OMEN GA1-1000 | Quick Setup Guide - Page 1
    Install the screw 3 into the card. 3 Plug the power cable into the card. 1 Installing a hard drive 1 To remove the access panel: 1 Pull the service door release latch. 2 Rotate the access panel off the product. 2 To install the hard drive into the drive cage: 1 Lower the hard drive into the
  • HP OMEN GA1-1000 | Quick Setup Guide - Page 2
    qualified AMD Radeon/NVIDIA® GeForce® graphics chipsets. 3. OMEN Accelerator app For information about the OMEN Accelerator app, go to http://www.hp.com/support. Quick tour Front 1 Power light 2 Stand 1 Sides 3 Service door release latch 4 Service door 5 Vent 2 Rear 6 6 Power connector 7 RJ-45
  • 1
  • 2

*926603-002*
926603-002
Replace this box with PI statement as per spec.
Installing a graphics card
Installing a hard drive
3
To replace the access
panel, rotate the panel
onto the product until it
locks into place.
2
To install the hard drive
into the drive cage:
1
Lower the hard drive
into the drive cage.
2
Install the four screws.
3
To install the hard drive
into the product:
1
Lower the drive
assembly into the
drive bay in the
product.
2
Slide the assembly
toward the back of the
product.
3
Tighten the captive
screw.
4
Connect the cable to
the rear of the drive.
1
To remove the
access panel:
1
Pull the service
door release latch.
2
Rotate the access
panel off the
product.
Installing hardware
If you purchased your product without a graphics card, you must first install a graphics card (purchased separately) before using this product.
You can also install an optional hard drive (purchased separately).
17015 Seven Pines Dr.,
Bldg. #1
Spring, TX 77379
832-717-4331
Color Side 1:
CMYK + PMS 186 + OVERALL MATTE VARNISH;
bleeds all sides
Flat size:
23.31 x 8.268 in
Fold 1:
4-panel
accordion
Color Side 2:
CMYK + PMS 186 + OVERALL MATTE VARNISH;
bleeds all sides
Folded size:
A5:
5.827 x 8.268 in
1
2
1
2
4
To replace the access
panel, rotate the panel
onto the product until it
locks into place.
1
3
2
1
2
2
3
4
2
1
To install a half-length
graphics card:
1
Insert the card into
the PCI slot.
2
Install the screw
into the card.
3
Plug the power
cable into the
card.
1
6
5
2
4
3
2
To install a full-length
graphics card:
1
Insert the card
into the PCI slot.
2
Place the bracket
on the card.
3
Tighten the
captive screw
on the bracket.
4
Install the non-
captive screw
into the bracket.
5
Install the non-
captive screw
into the card.
6
Plug the power
cable into the card.
1
To remove the
access panel:
1
Pull the service
door release latch.
2
Rotate the access
panel off the
product.
926603-002_SHIVA QSP w HW install_v14.indd
1
6/13/2017
4:17:45 PM