HP OMEN X Desktop PC 900-000i Hard Drive Replacement Instructions
HP OMEN X Desktop PC 900-000i Manual
 |
View all HP OMEN X Desktop PC 900-000i manuals
Add to My Manuals
Save this manual to your list of manuals |
HP OMEN X Desktop PC 900-000i manual content summary:
- HP OMEN X Desktop PC 900-000i | Hard Drive Replacement Instructions - Page 1
Hard Drive Replacement Instructions 863072-001 Before you begin Observe the following requirements before removing and replacing the hard drive. WARNING: Never open the cover while the power cord - HP OMEN X Desktop PC 900-000i | Hard Drive Replacement Instructions - Page 2
the rear of the hard drive (1). Pull the drive release lever (2), and then lift the drive up to remove it from the computer (3). 5. Remove the guide screws from the old hard drive. 6. Touch the replacement hard drive bag to the metal of the computer, and then remove the replacement hard drive - HP OMEN X Desktop PC 900-000i | Hard Drive Replacement Instructions - Page 3
Replacing the hard drive 1. Install the guide screws into the new hard drive. 2. Insert the drive into the drive bay until seated (1), and then connect the power and data cables to the - HP OMEN X Desktop PC 900-000i | Hard Drive Replacement Instructions - Page 4
recovery discs. To install the operating system, refer to the instructions included with your system recovery discs, or for U.S. product support, go to http://www.hp.com/go/contactHP. For worldwide product support, go to http://welcome.hp.com/country/us/en/wwcontact_us.html. IMPORTANT: Do not turn
-
1 -
2 -
3 -
4
 |
 |
863072-001
1
Hard Drive Replacement Instructions
Before you begin
Observe the following requirements before removing and
replacing the hard drive.
WARNING
: Never open the cover while the power cord
is attached. You might damage your computer or be
injured by the spinning fan blades.
WARNING
: Avoid touching sharp edges inside the
computer.
CAUTION
: A hard drive is extremely sensitive to shock
and impact. Do not bang or drop it. Do not touch the circuit
board. Static electricity can damage the drive.
CAUTION
: Static electricity can damage the electronic
components inside the computer. Discharge static
electricity by touching the metal cage of the computer
before touching any internal parts or electronic
components.
Tools needed
Phillips #2 screwdriver
Small screws are easily lost. Remove screws over a
surface that enables you to retrieve them if they fall.
Removing the hard drive
1.
Disconnect the power cord and all attached cables from
the back of the computer.
2.
To remove the access panel, loosen the captive Phillips
screw
(1)
, slide the access panel back, and then lift it
off the computer
(2)
.
863072-001