HP OMEN X Desktop PC 900-000i Memory Module Replacement Instructions
HP OMEN X Desktop PC 900-000i Manual
 |
View all HP OMEN X Desktop PC 900-000i manuals
Add to My Manuals
Save this manual to your list of manuals |
HP OMEN X Desktop PC 900-000i manual content summary:
- HP OMEN X Desktop PC 900-000i | Memory Module Replacement Instructions - Page 1
Memory Module Replacement Instructions 863070-001 Before you begin Observe the following computer before touching any internal parts or electronic components. Tools needed Phillips #2 screwdriver Troubleshooting If the computer displays a memory error after you have turned it back on, - HP OMEN X Desktop PC 900-000i | Memory Module Replacement Instructions - Page 2
3. To remove the access panel, loosen the captive Phillips screw (1), slide the access panel back, and then lift it off the computer (2). 4. Locate the memory modules: 1. Optical drive 2. Hard drive 3. Memory modules 5. Open both latches of the memory module slot (1), and then lift the module from - HP OMEN X Desktop PC 900-000i | Memory Module Replacement Instructions - Page 3
contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable
-
1 -
2 -
3
 |
 |
863070-001
1
Memory Module Replacement
Instructions
Before you begin
Observe the following requirements before removing and
replacing memory.
WARNING
: Never open the cover while the power cord
is attached. You might damage your computer or be
injured by the spinning fan blades.
WARNING
: Avoid touching sharp edges in the computer.
CAUTION
: Static electricity can damage the electronic
components inside the computer. Discharge static electricity
by touching the metal cage of the computer before touching
any internal parts or electronic components.
Tools needed
Phillips #2 screwdriver
Troubleshooting
If the computer displays a memory error after you have
turned it back on, turn the computer off and unplug the
power cord. Open up the computer and make sure the
memory module is inserted all the way into the slot, and
then press down on it to be sure it is firmly seated.
Memory compatibility
The computer uses UDIMMs (unbuffered dual in-line
memory modules) that must meet the following
requirements:
●
240-pin
●
DDR4-2133
●
Unbuffered, non-ECC (64-bit)
●
1.5 V
●
32 GB maximum installable memory
Because the memory uses dual channels, you must use the
same memory module type for both sockets.
NOTE
: The actual memory transfer speed might vary based
on the processor used in your computer.
NOTE
: Memory performance might vary due to different
system configurations.
Removing the memory module
1.
Press the power button to turn off the computer.
2.
Disconnect the power cord and all attached cables
from the back of the computer.
863070-001